Prostart Not Starting

To program the tach hold down the hood pin for 5 seconds. Release it and when the parking lights come on quickly press and release the hood pin again. Press and hold the brake pedal. Press both the lock and unlock buttons on one remote at the same time until you hear the remote starter module click 4 times. Then release the brake. Start the car and let it idle for a few seconds. Press the brake pedal once more and release it. Listen to hear the module click 5 times. Then shut off the engine. Close the hood and try the remote starter. Don't look at the lights as they may or may not remain on depending on the vehicle and existing lighting conditions. If this fails to work, post the year, make and model of your car. You may not have the correct tach wire. Also make absoulutely sure that your ground for the remote starter is into a clean and paint free section of the vehile body and not into another wire or dash bracket. These are not good sources for ground. The remote starter references the tach signal off your ground source.sparky