1994 Yukon Door Locks

I have a 1994 Yukon GT 2 Door I'm trying to get the doorlocks to work on a Code Alarm 535 remote start with a 425a brain I think I have defined the the lock type as  a 5 wire system one constant hot wire....... two wires always at ground.... and two wires that switch from gnd to +12v when pressed(unlock.lock) I've tried the circuit on this site and all it does is lock up the drivers door actuator any suggestions would be greatly appreciated

Power Lock	LT BLUE	Under Driver Speaker
Power Unlock	BLACK/ WHITE OR BLK/RED	OR Boot in Door Jam

2 SPDT RELAYS:

Cut LOCK  & UNLOCK Wire in Half.

One Half goes to SWITCHOne Half goes to ACTUATOR

Relay 1

LOCK:

PIN 87 =  12 Volts ( + ) ConstantPIN 87a =  wire from Door Lock SwitchPIN 30 =  wire to ActuatorPIN 85 = Negative Lock Output from AlarmPIN 86 = Constant 12 volt ( + )

Relay 2

UNLOCK:

PIN 87 =  12 Volts ( + ) ConstantPIN 87a =  wire from Door UnLock SwitchPIN 30 =  wire to ActuatorPIN 85 = Negative UnLock Output from AlarmPIN 86 = Constant 12 volt ( + )

MO

Don't Learn from Others Mistakes

You Might Be the One That Knows.

thank you for fast reply one more stupid newbie questions how do I tell which half goes to actuator and which goes to switch? thx again

After cutting Both Wires .....

Meter ( Usually side that goes to Door ) wire as you press on Lock / Unlock Switch on door. 

Read this for general idea:

http://www.wiringinstructions.com/203.htm

MO

Don't Learn from Others Mistakes

You Might Be the One That Knows.

Wired it according to the info you gave me still not working when I hit lock nothing happens ...when unlock it cycles beteen unlock and lock ......

anybody have a suggestions??