Ford ECM Tx and RX

Installing bypass module PKF-1

Is the ECM located on the pass. side kick panel? Anyone know off the top of their head which is Tx and RX? Just about done -

Thanks

follow the 4 pin plug off the ign cylinder...it'll go to a plug to the right of the column... thats usually where i grab these wires.....

any more info would require you mentioning what type of Ford vehicle you are working on.....

thanks, it's a 00 expdeition.

Also on the door triggers I used the light blue/white from the factory remote entry and hooked the - door trigger wire to it and it kept saying the door was open when it was close and i would open while armed and it did not sound.

It is the compustar remote start/alarm combo  2wssas

thanks again!

Mark

Jeff,

   Thanks for the reply, I will give that a try. I miss Canada! I am from Ont.

take care-

         Mark

I put the RED / white wire with the light blue/white and it does nothing.

I see a run of wires that look like they come from the ignition area, any idea which 2 of the 4?

Thanks

I finally got the it bypassed. The problem I have now after remote starting the blower motor does not work. I have the white acc. wire from the remote starter hooked to the largeer grey and yellow wire per the manual, am I missing something?

Thanks ,

         Mark

Ign - 1 blue/lt green

Ign - 2 gray / YELLOW (2nd acc)

acc -1 RED / black

acc -2 BLACK/ green.