eliminating one touch for 530T?

Hello, I just installed a 530t module with my clifford matrix RSX 3.5 alarm system, it works fine but I have a few issues/questions.

1) Is it possible to eliminate one touch operation? I find it annoying if I only want to crack my window about 1inch. And my car already have one touch built in.2) The 530T is wired to the GWA output of my alarm system, but it sets of the shock sensor whenever my windows are rolled up after arming, anyone else with this problem or a possible solution?3) Is it possible to have the 530T hooked up to both the GWA output and a aux channel so I can roll down then roll up my windows without having to disarm, wait 10sec and rearm?

1. No 2. Your shock sensor is too sensitive. Turn it down. Or....      The 530T has an output that can be use to trigger a relay that breaks the trigger wire of the shock sensor while the windows are going up. Its a grey wire. Wire a relay as follows:      86 - constant +12v      85 - Above grey trigger wire      cut green or blue wire leading to shock sensor.      30 - one side of above wire      87a - other side of above wire 3. No

You could add a timer relay to the ground when armed wire, set it for 10-12 seconds or however long it takes your windows to raise.  Everytime you arm the car it will trigger the relay to run for the set time, then remove the relay will drop out, removing the ground, allowing you to hook it up to an AUX channel.Kevin Pierson