Wiring Saturn Ion

Home / the12volt's Install Bay / Car Security and Convenience / Wiring Saturn Ion (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

infinitehustle8

Member - Posts: 8

Joined: April 27, 2006

Location: United States

Posted: April 28, 2006 at 1:44 AM / IP Logged

I have 2 scenarios going on with my car.

1st problem:I recently wired an 05 saturn ion with a compustar alarm/remote start.Everything works except the remote start.The remote start only works almost immediately after i turn off the engine.Any other time when i try to activate the remote start, i can just hear the starter attempting to turn over.There is a clicking sound.The passenger side door pin is broken.I was wondering if that had anything to do with the remote start not working properly?

2nd problem: Yesterday, i tried to program the 2nd keyless enty remote so i resetted the alarm by turning the key over to the accessory position 5 times.I tried to program the remotes at the same time but had no success.Still only one remote works but now i lost the features that had previously been programmed such as shock,window paging,and arm.Basically the only thing that works now is keyless entry.I would like to correct it.Does anyone have any suggestions?any help would GREATLY BE APPRECIATED.Thanks in advance.

Search for other posts by infinitehustle8

customak47

Copper - Posts: 164

Joined: October 25, 2005

Location: Vanuatu

Posted: April 28, 2006 at 12:05 PM / IP Logged

to program remotes: turn key from accessory to ignition 5 times slowly, and watch for the parking lights on the dash to blink when it enters program mode. if they don't blink, turn key from acc to ign slowly until they do, wait two sec then hit lock on 1st remote, park lights blink, wait one sec, hit lock on 2nd remote, park lights blink. shut key off and you're done. As far as starter not working, could be a number of things. try remote starting it while sitting in it and see if the security light blinks when its trying to start. If it is, reprogram antitheft bypass. The door pin should have nothing to do with it. Make sure your harness is plugged in tight and all connections are nice and tight. Good luck.

My rifle is my friend...

Chris Luongo

Platinum - Posts: 3,746

This member consistently provides reliable information

Joined: May 21, 2002

Location: Massachusetts, United States

Posted: April 28, 2006 at 7:20 PM / IP Logged

What method are you using to bypass the car's Passlock anti-theft system?

infinitehustle8

Member - Posts: 8

Joined: April 27, 2006

Location: United States

Posted: April 29, 2006 at 1:09 PM / IP Logged

thank you. i will try this

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Wiring Saturn Ion

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.