2002 chevy blazer remote start

Home / the12volt's Install Bay / Car Security and Convenience / 2002 chevy blazer remote start (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

duallyit

Member - Posts: 17

Joined: April 30, 2006

Location: United States

Posted: April 30, 2006 at 2:39 PM / IP Logged

I have a remote start asian wolf 2009 version 2, bypass box 555l which by passes the factory alarm . The alarm says that you can hook up both wires, door trigger and dome light supervision .This I can't figure out cause the door trigger switches has to be diode driver side tan ,passenger door orange,rear doors and hatch is dark blue to the bcm.If all these have to be diode how do you connect them to a dome light supervision ?and can you stil ?

The factory alarm has it were you can double click the remote the back glass then will pop the glass window while the alarm is still activated ,this then allows the light to also come on and stay on when i close the back glass the light goes off .

If I connect the door trigger switch to the dome light supervision from the alarm how does the trunk release know not to set off the alarm ? When the button is hit to relase the trunk? Because this will then turn on the dome light supervision and the alarm will then sound off.

Please help me if any one has the proper diagram way of connecting this alarm up to simplify my situation with the bypass hooked up . I am about to burn up my brain !!!!

duallyit

Back to Top

Twelvoltz

Platinum - Posts: 2,384

This member has made a donation to the12volt.com. Click here for more info.

This member consistently provides reliable information

Joined: March 24, 2005

Location: New Jersey, United States

Posted: April 30, 2006 at 3:34 PM / IP Logged

1. Here is a nice how-to diode isolate guide that shows not only how the diode is supposed to face, but also where to cut it in. As far as the dome supervision, your system probably only provides a - 500ma output, and is not typically enough current to turn the dome light on, you will more than likely need a relay for dome supervision.

2. The BCM has a wire that will pop your rear hatch, make sure to set the alarm to disarm anytime you use the aux chanel output.

3. The 555L does not bypass the factory alarm, it bypasses the factory antitheft system, allowing the vehicle to start, these are two seperate items. The factory alarm can be disarmed by providing a ground pulse to a specific wire.

Hope this helps

2002 Blazer wire colors/locations.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2002 chevy blazer remote start

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.