Autopage CPX-RS2, 98 Windstar

Hi there I'm installing this system on my 1998 ford windstar, 3.8L

http://www.autopageusa.com/t_inside.cfm?action=products&catid=1003&prodID=c6960571-607a-490a-a914-90b3ee6bbf23

I managed to have the key less entry work but no luck with the remote starting?

after my searchin different places I found different wiring here and other forums ?

1- is there is 3 ignnition wire on my car or not? according to your wiring , YES & acorrding to others NO

2-is the tac connection is optional or must?

3- Im not sure if my van has the immobalize (transponder key)?I asked ford about my car with vin # they said it dosent have one.as a  mtter of fact  I had 2 copys done on my original key at wallmart  (normal keeys $2 and they woked fine)?

so im not sure waht is the problemfor this connection

any input will be highly apreciated.

Thanks in advance

Thanks

"it has no transponder key"

very good to know ?do I have to connect the disarm wire as it is in the wiring diagram here?

"two ignition wires and two accessory wires "

I did connect the 2 ignition what I have to do with the accessory wires ? which wires I could connect to crx-sr2?

go to any odd color injector. very easy to see and hook up"

where ic ould found those I'm sorry I'm new to that?

thanks for your help

thanks for your help.

I did  the connection as you mentiond but with one accesory wire only as the rs2 sysytem has only on connection

but still not working, can i just test remot starter without the 8 wires harness (the one with red color i add)?

thank

can i test the start remote without connecting the harnes with 8 wires ?

plz any proff, will be highly apreciated

any ideas?

thanks