2006 Pontiac G6 remote start

I need the wiring info for a 2006 pontiac G6. Thank you very much.Good Luck!

-Thad

for what? the radio? alarm/remote start? little more specific

SoundAudio wrote: Alarm/Remote Start sorry

12volts      RED / white (2A)       +       ignition harness Starter      yel or pur/wh (not for rem st)      -,+      PCM, blue plug, pin 23 or 26 Notes: Starter wire is not required for remote start. When the vehicle sees that the ignition wire has voltage and the accessory wire lose voltage, it automatically cranks the starter. The PCM (Powertrain Control Module) is in front of the battery on the driver side fender. Second Starter      N/A             Ignition      pink       +       ign harn or BCM, C4, pin D3 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Second Ignition      N/A             Third Ignition      N/A             Accessory      brown       +       ign harn or BCM, C4, pin C8 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Second Accessory      N/A             Keysense      not required             Power Lock      white       -       driver kick or BCM, C1, pin 66 Notes: Lock is a straight negative trigger. Unlock is negative trigger thru a 1.5K ohm resistor. MUST use relays. The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Power Unlock      same as power lock wire             Lock Motor      gray/black to gray       5wi      driver kick or BCM, C3, pin A5 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Unlock Motor      tan       5wi      driver kick or BCM, C3, pin B1 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Parking Lights+      brown       +       BCM, C3, pin A7 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Parking Lights-      BROWN / white       -       switch or BCM, C2, pin 5 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Hazards      white       -       switch or BCM, C2, pin 9 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Turn Signal(L)      lt. blue/white (F), yellow (R)      +       BCM, C1, pin 38 and C3, pin A9 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Turn Signal(R)      dk. blu/wht (F), dk. green (R)      +       BCM, C1, pin 56 and C3, pin A12 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Reverse Light      lt. green       +       inside rearview mirror Door Trigger      gray/black (D), tan/white (P)       -       each kick or BCM, C1, pins 51 and 72 Notes: Use both wires and diode isolate each. The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Dome Supervision      gray       -       BCM, C3, pin A10 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Trunk/Hatch Pin      ORANGE / black       -       BCM, C1, pin 18 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Hood Pin      pink/black       -       pin switch or BCM, C1, pin 69 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Trunk/Hatch Release      BROWN / white       -       BCM, C1, pin 71 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. The trunk release motor wire is tan/white (+) at the rear fuse block in the driver side of the trunk, black plug, pin F10. Power Sliding Door      N/A             Factory Alarm Arm      factory remote only             Factory Alarm Disarm      factory remote only             Disarm No Unlock      with ignition and Passkey             Tachometer      NOT pink       ac       any fuel injector Wait to start      N/A             Brake Wire      white       +       BCM, C1, pin 42 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Parking Brake      lt. blue       -       switch or BCM, C1, pin 59 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Horn Trigger      tan       -       switch or BCM, C2, pin 14 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Memory Seat 1      N/A             Memory Seat 2      N/A             Memory Seat 3      N/A             Interface Module:      Category: Immobilizer Bypass      Required: Yes      Type: PASS-Key III+ Part #: OM-GMC-6 Alternate Part1 #: 556UW Alternate Part2 #: DesignTech 20402 Alternate Part3 #: DesignTech 29402 Notes: Standard on all models. In addition to the bypass module, you will also need to follow the interface information on DirectFax document 1603 using a 1300 ohm resistor. Interface Module:      Category: Door Lock Interface      Required: No      Type: Data Bus Part #: IM-GMSD-1 Alternate Part1 #: 456LW There ya go hope it goes good for ya.

Is it worth getting the data bus doorlock and factory alarm interface or just use the a resistor and relays for the door locks and ignore the factory alarm?  I already have the immobilizer bypass. Thanks.Good Luck!

-Thad

SoundAudio wrote: Is it worth getting the data bus doorlock and factory alarm interface or just use the a resistor and relays for the door locks and ignore the factory alarm? I already have the immobilizer bypass. Thanks.

interfaces make things a lot smoother for the installs. i guess that's totally up to you.A DMM is a beautiful thing.

MECP Advanced Installer Certified.

I just did one last week,I used a PKG7 bypass module and it worked great.The only glitch was I had to hook up my Crimestopper RS900 to a tach source to stay running.