keyless entry programming

Home / the12volt's Install Bay / Car Security and Convenience / keyless entry programming (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

caverspencer

Member - Posts: 1

Joined: November 23, 2006

Location: United States

Posted: November 23, 2006 at 10:09 PM / IP Logged

I just bought a '97 accord that has an alipne keyless entry. The remote is a 4 button SEC-8426 FCC ID: B23AT68

I ahve also located teh "brain" the FCC ID on it is B23AR55

Today my son was playing with the remote and now it doesn't work.

Can someone point me to some programming instructions for it?

I have tried a couple of methods one was to hold the vallet switch on, cycle the ignition 3 times and press teh remote button. No luck with that one. Another method said to open open up the "brain" and press the reset button while holding the valet switch. prblem witht aht is the board does not have a reset switch. I can see where ti would be, but myine does not hav ea reset switch.

HELP!!!!

Also what do the 4 button do? All that worked before was the blue panic button would both lock and unlock the door. I dislike that because if you press it twice you walk away thinking its licked when its not. What to the other buttons do? They are: Mode, EXT2/EXT3, EXT!/Valet and TX/Panic

master5

Silver - Posts: 1,123

Joined: October 10, 2006

Location: United States

Posted: November 24, 2006 at 5:33 PM / IP Logged

Its been a while since I have seen an alpine keyless, it must be pretty old.

I do not remember the programming procedure. You might want to check the most obvious things first like did the battery die or did playing with the remote put the system in valet. Otherwise if no one here has access to a manual you might try Alpine technical assistance and they may link you to one for free from archives or perhaps for a fee send you one.

As far as the buttons I believe...

Mode: 2 car operation, but not 100% sure

EXT2: OPTIONAL OUTPUT ie: trunk release, etc

EXT3: another OPTIONAL OUTPUT ie: car finder, window roll ups, etc.

EXT/valet: valet feature through remote, possibly another optional output as well

TX/Panic : For panic mode

master5

Silver - Posts: 1,123

Joined: October 10, 2006

Location: United States

Posted: November 24, 2006 at 5:36 PM / IP Logged

Oh,one more thing..you might be able to do a manual reset by unplugging the brains main power harness for a few minutes, then plug it back in, I use this technique quite often to eliminate "glitches" or freeze ups.

Good Luck

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

keyless entry programming

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.