2004 mitsubishi outlander remote start
Welcome Guest :)
r2d97
Member -
Posts: 31
Joined: January 07, 2004
Location: United States
Posted: November 30, 2006 at 5:59 PM / IP Logged
I am installing a valet 561r remote start system in a 2004 mitsubishi outlander and was wondering if there was a different wiring diagram for this vehicle compared to the eclipse. I was curious to see if this vehicle uses the keysense feature and how to bypass it. Thank you.
KarTuneMan
Platinum -
Posts: 7,056
Joined: December 14, 2004
Location: Isle Of Man
Posted: November 30, 2006 at 7:55 PM / IP Logged
Keysence feature ?
| MODEL | YEAR(S) |
| OUTLANDER | 2003 -2005 |
| KEY | T-HARNESS | IMMOBILIZER |
| N/A | N/A | MITSUBISHI TRANSPONDER ANTI-THEFT SYSTEM, Requires 791 Bypass Module and extra Ignition Key |
| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | BLUE/WHITE (+) | IGNITION SWITCH HARNESS |
| STARTER | BLACK / YELLOW (+) | IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | BLUE/BLACK (+) | IGNITION SWITCH HARNESS |
| IGNITION 2 | N/A | |
| IGNITION 3 | N/A | |
| ACCESSORY /HEATER BLOWER 1 | BLUE/RED (+) | IGNITION SWITCH HARNESS |
| ACCESSORY /HEATER BLOWER 2 | BLUE / YELLOW (+) | IGNITION SWITCH HARNESS |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | GREEN / WHITE (+) | @ 15-PIN PLUG, PIN 2, BELOW FUSES |
| POWER LOCK | LIGHT GREEN/ RED (TYPE B) | @ ETACS ECU, Pin 34, See NOTE *1 |
| POWER UNLOCK | BROWN / RED (TYPE B) | @ ETACS ECU, Pin 33, See NOTE *1 |
| DOOR TRIGGER | BROWN (-) | @ 15-PIN PLUG, PIN 10, BELOW FUSES |
| DOMELIGHT SUPERVISION | RED (-) Requires Part #775 Relay | @ PIN 1, IN 3-PIN PLUG, BELOW FUSES |
| TRUNK RELEASE | N/A | |
| SLIDING POWER DOOR | N/A | |
| HORN | LIGHT GREEN/ BLACK (-) | @ ETACS ECU, PIN 44, See NOTE *1 |
| TACH | WHITE/ GREEN | @ ENGINE SPEED DETECTION CONNECTOR, See NOTE *2 |
| WAIT TO START LIGHT | N/A | |
| BRAKE | BLUE/ORANGE (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | BROWN / WHITE (-) | @ ETACS ECU, PIN 25, See NOTE *1 |
| ANTI-THEFT | TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY | TRANSPONDER @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE *1 THE ETACS (Electronic Timing/Alarm Control System) ECU (Electronic Control Unit) IS ATTACHED TO THE BACK OF THE FUSEBOX. NOTE *2 THE ENGINE SPEED DETECTION CONNECTOR IS A SINGLE PIN CONNECTOR IN THE FUSE/RELAY BOX UNDER THE HOOD |
Follow the12volt.com
Monday, April 29, 2024
• Copyright © 1999-2024 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
Topic Closed)
Members
Search
Register
Login
Printable version
