remote start starts once i plug in battery

I finished an install on a 1993 acura integra today but this was very strange... Once I plug in the battery, the car would automatically stopped. I followed the instructions in the manual and and connected the right wires from the car according to the wiring diagram from bull dog. What would cause this? I didn't use any relays. I have everything installed from 12 volt constant, tachometer, brake switch, hood pin, ignition 1 and 2, output accessory 1, and negative. Best Regards, Tabo

My apologies, I mean the car would start right away once I plug it the remote starter control module. So annoying, it is suppose to start when I press the remote. Also, I didn't hook up the parking lights and there was no horn available.

What unit did you install.....? If it's "Starting" when you plug the brain in, you must have some of the Main harnes wires hooked up incorrectly, sending 12volts to the starter.   Tell us what you installed, and what you connected to, on the main harness. (your cars ign. harness, to what you connected to the main power harness on your remote start)

I installed everyhing as mentioned in the first post. However, I did not install the followingStarter Output shutoff Parking Lights Horn I'm positive I connected everything properly because I double checked. Are those 3 things required?tabo

Are you saying that the starting is kicking in or that the remote start activates?

They're not required for the remote start to work......but it's a Honda! Just one connection, should be able to find parking lights almost anywhere....don't you want to know when the remote starter is on?