506t problem

Alright I have a 1990 Nissan 240sx SE, I installed a Viper 791XV. I have a Tilt sensor, Back up battery module, Glass break sensor, 2nd siren inside. Anyways I just got done installing the alarm, and everything works except my 506T glass break sensor. I isolated the problem to it because before none of my extra sensors worked, so I unplugged each one until I got to the glass sensor and everything worked harmonously.

The problem I'm facing is that when I arm the car it shows the trunk being triggered while arming, so everything thats attached to the trunk trigger doesnt work. When I unplugged the glass sensor everything worked as expected, and the remote showed everything a ok the trunk wasnt being triggered.

So as I sit inside the car looking at the module for the glass sensor the LED's light up every time the siren chirps when arming so thus causing the problem.

Anyway to solve the problem? I adjusted the sensitivity even on low it still triggers while arming. Other than that everything works beautifully. I have everything diode isolated, I'll check to see if its backwards as well but anything else?

Just like you said I tapped into the blue wire on the main harness the trunk trigger. Does the shock sensor activate after you arm the car?