1994 bronco, remote start

This is my first remote starter install. I'm not the best at this however, $300+ for someone to do this isn't something that I'll do. So, I'm hoping no one will blantenly tell me to have a "proffesional" do it because that's out of the question. I have hooked the wires up as described in my diagram, I have two or three wires that all show power in the run posision on my truck and was wondering if there is a certain one to use. It is a 1994 Ford Bronco Eddie Bauer edition. I have re-done all the mechanics on the truck and have made it look good and run like champ, I just wanted to install a remote start more or less just because. The remote start is a Royal Gaurd TH-800 I believe. After installing everything with the exception of the keyless entry, I would attemt to remote start the vehicle and it would just set off the alarm. Any help in this matter will be greatly accepted. Thanks!

Do you have the vehicle tech sheet?  If not you can find one on this site.

Is that the page with all the colors of the wires and such? If so, I did get it but it was after I had posted. I'll see what I can do, I've always enjoyed doing stuff like this but electronics kick my back side. Heck, I pulled the motor, rebuilt it and put it back in by myself without any help. That was a fun two weeks!

I appriciate it alot slawson2000, that was what I needed...