remote start for Aladdin

Home / the12volt's Install Bay / Car Security and Convenience / remote start for Aladdin (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

podrido

Member - Posts: 3

Joined: February 02, 2003

Location: Canada

Posted: February 14, 2003 at 12:33 PM / IP Logged

what's up velocity

i hooked up all the wires that seem to be required for a 95 eagle talon esi, the alarm is an Aladdin a2000. Everthing is programmed and working, i remote shows that the car is on but the car isn't. I tried hooking up the start assist wire to the clutch bypass but i couldn't so i just disconnected the harness for the clutch and the car normally starts without pressing on the clutch. Also , i got a wiring diagram from the net and it said that the ign2 wire is the heater/ac , so i never used a relay for a second ignition as i just assumed that it is the Heater wire.

i've been trying to figure out the problem for a while now, the car is a mess with wires hanging around everywhere....can you please reply A.S.A.P

Thanks

Velocity Motors

Moderator - Posts: 12,488

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Fabrication. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: February 14, 2003 at 12:54 PM / IP Logged

Did you go through the proper exit procedures as described on page 11 of the color manual ? If you did do this, try sitting in the car while you go through the manual start setup & this time, depress the clutch while remote starting & see if the car starts. If it does, then you have to hook up the clutch bypass to the Aladdin a-2000. If it still doesn't start, then you have a wiring problem that you will need to trace back. Here is a wiring diagram that I have for this vehicle. Please check this and re-check the wires with a DMM to ensure that you have the correct wires. DO NOT ASSUME THE COLORS ARE RIGHT, You may have tapped into a similiar colored wire by accident and the system is not responding the way it should.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Search for other posts by Velocity Motors

podrido

Member - Posts: 3

Joined: February 02, 2003

Location: Canada

Posted: February 15, 2003 at 11:12 AM / IP Logged

i tried sitting in the car and pressing the clutch ....and the only response was the lights on the dash. I also checked every wire that i hooked up with the DMM and all the circuits were verified. Moreover i never got the wiring diagram.

Thanks

Velocity Motors

Moderator - Posts: 12,488

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: February 15, 2003 at 11:23 AM / IP Logged

Verify all your wiring connections to this diagram: Your door switch has to be hooked up as well.

| 12V|white |+ |ignition harness |

| POWER LOCK|RED / blue |- |*1 |

| POWER UNLOCK|BROWN / red |- |*1 |

| HEADLIGHTS|red |- |steering column |

Notes:

*1 Located behind the glove box in a harness. To unlock only the drivers door on models with keyless entry. Use BROWN / blue negative (-) trigger at the relays behind the radio. *2 Found in a gray 20-pin connector. *3 To avoid the dome light delay use RED / white (-) at the door open indicator at the instrument cluster. The RED / white will also catch the rear hatch. *4 The PCM is located on the drivers side of the engine compartment or behind the center of the dash depending on motor. *5 The data link connector is under the driver side dash.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

remote start for Aladdin

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.