micro dlr4

Home / the12volt's Install Bay / Car Security and Convenience / micro dlr4 (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

killer cougar

Member - Posts: 11

Joined: September 08, 2007

Location: North Carolina, United States

Posted: September 08, 2007 at 8:50 AM / IP Logged

I just recently in installed the Micro DLR4 keyless entry system into my 1993 Jeep Grand Cherokee Laredo. The system has an aux output for a remote start, trunk release, power window roll up, etc. Is it possible to wire the output so that it turns on a set of lights? Here is a pdf of the manual and install instructions. http://www.microalarm.com/pdf/dlr4_inst.pdf

B-Stat

Back to Top

JWorm

Platinum - Posts: 2,208

Joined: December 11, 2002

Location: New Hampshire, United States

Posted: September 08, 2007 at 10:37 AM / IP Logged

You need to use a latching relay. A DEI 611T would work...can be found on eBay. I have seen some descriptions of it say it can handle 30 amps of current, and other descriptions say only 5 amps. If the lights you are using are high current, you may need to have the 611T trigger a 30 amp relay.

Back to Top

killer cougar

Member - Posts: 11

Joined: September 08, 2007

Location: North Carolina, United States

Posted: September 08, 2007 at 10:55 AM / IP Logged

Thanks

B-Stat

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

micro dlr4

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.