2002 sunfire, ultrastart 1256m and plxr

Installing a Ultrastart 1256M on my 5 speed 02' Sunfire. I have installed the PLXR unit to bypass my passlock II. I have connected all the wires - 2 to the wires under the steering column, one to constant power, and after programming, to the orange GWR of the ultrastart.

It does bypass the passlock II, however, my passlock II light and check engine light are now always on as long as the PLXR is plugged in.

Any suggestions on what could be causing this?

Also, any idea how to bypass the clutch?

If I remember right on the PLXR you need to hook up a wire to ignition and to your starter also. ignition should be the pink on the PLXR and Starter should be Orange. Its been a while since I've used one, so I might be wrong, but I would double check the wiring guide. If that doesn't work one thing I've had to do in the past especially with Saturns is hook up the keysence wire. It should be a green wire at the ignition switch that goes to ground with the key inserted.  Thats all I got off the top of my head.

As far as the clutch goes, the best advice is test the wires at the clutch  to see what happens when you depress the pedal. I'm assuming the remote starter you are using is designed to work with a manual tranny, if not don't even attempt it.

Yes, he has the correct model remote start for a manual.

Thanks.

I think I have the clutch bypass figured out. The purple wire of the clutch goes + when pressed, so I am going to wire a SDPT relay as follows:

85- GRD

86 - neg GWR from remote start

87- + to clutch (purple)

30- + 12 volts

For the passlock module, I couldn't see a keysense wire, but will double check. Does anyone know if the sunfire does have one?

What about diodes Do you think installing them would work too?