Indiglo Gauges Install

it's tricky, I did them in my Jeep.you need to push the plate down flat against teh cluster, and slide the edge of teh indiglo plate under the gauge needle's base till it goes right up against the center-pin itself. then the Indiglo plate will drop over the gauge needle easily. Get the Indiglo plate over all of the needles first, then go one by one and push them under the needle centers, letting the plate pop over them and lay flat.The rest is fairly easy. You can tap into the illumination and ground wires right at the headlight or dash-illum switch/control behind the dash for power. Then they illuminate when ya turn on the headlights or running lights.This is how they came out in the Jeep:Good luck!-GlassWolf

Pioneer Stage-4, Orion, DynAudio, Fi