Members
Search
Register
Login
Posted: March 30, 2024 at 5:52 PM / IP Logged
New subscriber here. I have a 1990 Peterbilt that I am using to tow a fifth wheel camper. The truck has the standard 7 round pin trailer light plug with seperate brake and turn signal circuits. The trailer has the standard RV style 7 flat pin trailer plug and the brake and turn signals are combined on one filament.
I have tried the two relay setup for each side. Brakes work fine, turn signals work fine. Problem is when the brakes are applied and the left or right turn signal is on the trailer turn signal lights flash off sequence from the truck.
Suggestions Please.
.
If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.
Printable version
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
| Search the12volt.com |
Follow the12volt.com 
Thursday, May 9, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Thursday, May 9, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
