2003 ram door locks

Does anyone have a diagram for the single wire door locks on the 2003 ram.

I'm working on the same vehicle.  It's apparently 819 ohms for lock and 320 ohms for unlock through a single wire.... you can find it in the driver's kick, it's white with a green stripe..... i haven't had success with it as of yet, but i do know that wire is the one because it tests with ground and locks the doorsI hate these new brainstorms that Chrysler comes up with... if you happen to run accross the tach wire, email me directly... maximumboom2000@yahoo.ca   ..... thanks

this is for a 2002, i will double check on the 2003 and send info to both of you.... WHITE/ DARK GRN Wire Must See Ground Through 820 Ohm Resistor For Lock And Ground Through 330 Ohm Resistor For Unlock.Alt: 220 Ohms. Confermed By More Than One Source The 220 Ohm Worked On Unlock. Tach Signal TAN/RED IGNITION COIL Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

I have done a few of those and the thing that I had a hard time getting used to was remembering that even though they  operate with a neg. pulse you still have to run relays to amplify the ground, and then run the pulse through your resistors. Just a thought!! I hope it helps.g.g.