2012 Volkswagen Eos Wiring

installing remote starter. 2012 VW Eos wiring diagrams?

EOS      2009-2015 KEY      T-HARNESS      IMMOBILIZER N/A      N/A      VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1 VEHICLES WITH SMART KEY AND PUSH TO START REQUIRES A DBALL2 INTERFACE FOR REMOTE STARTING PART      COLOR      LOCATION      DIAGRAM 12 VOLT CONSTANT      BLACK/RED (+), 50 AMP      @ VESCM, (2-PIN PLUG(I), PIN 1, NOTE #2       STARTER      RED/BLACK (+)      @ VESCM, (12-PIN PLUG(G), PIN 1, NOTE #2       STARTER 2      N/A            IGNITION 1      BLACK (+)      @ VESCM, (12-PIN PLUG(G), PIN 11, NOTE #2       IGNITION 2      N/A            IGNITION 3      N/A            ACCESSORY/HEATER BLOWER 1      N/A            ACCESSORY/HEATER BLOWER 2      N/A            KEYSENSE      N/A            PARKING LIGHTS ( - )      N/A            PARKING LIGHTS ( + )      GRAY/YELLOW (+), NOTE #6      @ VESCM, (16-PIN PLUG(E), PIN 1, NOTE #2       POWER LOCK      BROWN/GREEN (-) NOTE #3      @ DDCM, (32-PIN PLUG), PIN 32, NOTE #4       POWER UNLOCK      Use LOCK wire, (-) thru a 250 Ohm Resistor            LOCK MOTOR WIRE      YELLOW (+), 5-Wire Type      @ DDCM, (20-PIN PLUG), PIN 13, NOTE #4       DOOR TRIGGER      BROWN/YELLOW (-)      @ DDCM, (20-PIN PLUG), PIN 7, NOTE #4       DOMELIGHT SUPERVISION      RED/PURPLE (-)      @ VESCM, (12-PIN PLUG(B), PIN 11, NOTE #2       TRUNK RELEASE      PURPLE (-), NOTE #8      in DRIVERS KICK PANEL or CSCCM, (8-PIN PLUG), PIN 6, NOTE #5       SLIDING POWER DOOR      N/A            HORN      BLACK/WHITE (+)      @ VESCM, (6-PIN PLUG(J), PIN 6, NOTE #2       TACH      NOTE #9      @ Any FUEL-INJECTOR       WAIT TO START LIGHT      N/A            BRAKE      BLACK/RED (+), (TEST with IGNITION KEY ON)      @ VESCM, (16-PIN PLUG(E), PIN 2, NOTE #2       FACTORY ALARM DISARM      NOTE #7      @ DDCM, (20-PIN PLUG), PIN 16, NOTE #4       ANTI-THEFT      VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1      @ IGNITION SWITCH TUMBLER       NOTES NOTE #1: VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # 791 Bypass Module, for REMOTE STARTING ONLY! Part # DLPK-CANBUS MULTI for REMOTE STARTING and DOOR LOCKS (Resistors for DOOR LOCKS, NOT REQUIRED) NOTE #2: the VESCM, (Vehicle Electrical System Control Module) is the RELAY BOX, Under the DRIVERS DASH. NOTE #3: this vehicle uses a 1-WIRE DOOR LOCKING SYSTEM, that Requires Extra Parts for operation. See DIAGRAM. The use of Bypass Module DLPK-CANBUS MULTI will do the ANTI-THEFT and DOOR LOCKS without the use of relays and resistors. NOTE #4: the DDCM, (Drivers Door Control Module) is located in the DRIVERS DOOR. NOTE #5: the CSCCM, ( Comfort System Central Control Module) is located behind the GLOVE BOX. NOTE #6: for the PARKING LIGHT FLASH option, it will be necessary to break the HEADLIGHT Switch OFF wire, BLACK/YELLOW (+), located at the VESCM, (16-PIN PLUG(E), PIN 16. NOTE #7: to DISARM FACTORY ALARM (if needed) Requires a (-) thru a 250 Ohm Resistor on the GREEN/WHITE (-) wire, requires resistor and relay. TEST this wire while turning the KEY in the DRIVERS DOOR. NOTE #8: TEST this wire while Opening the TRUNK with the Handle on the REAR of the Vehicle NOTE #9: when using the TACH wire, use a BROWN/BLACK, BROWN/WHITE, BROWN/PURPLE or ROWN/GRAY, they all test (AC)~wirewise~ Verify all wiring with your meter before making any connections!