the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2003 Dodge 2500 alarm

Home / the12volt's Install Bay / Vehicle Wiring Information & File Requests / 2003 Dodge 2500 alarm (Topic Closed Topic Closed)
Welcome Guest :)

Post ReplyPost New Topic
< Prev Topic Next Topic >
gators67 
Member - Posts: 11
Member spacespace
Joined: April 21, 2003
Location: United States
Posted: April 26, 2004 at 7:30 PM / IP Logged  

 I recently put in an alarm with power locks, but the single wire system is stumping me...the color of the door lock is WHITE/ green stripe, it says to add a resistor for lock and one for unlock, I tried using the resistors from the dodge carvan but to no avail..should I be using a relay system? If so would someone be kind enough to email the diagram or add any other helpfull info PLEASE !!! Thanks so much !!!Confused in Florida

gators67
rudbwoy69camaro 
Silver - Posts: 350
Silver spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: June 10, 2003
Location: United States
Posted: May 02, 2004 at 11:37 AM / IP Logged  
2003 Dodge Ram Pickup

ItemWire ColorPolarityWire Location
12Vpnk/blk & RED / wht+ignition harness
STARTERyellow+ignition harness
IGNITIONblue (16 awg)+ignition harness
ACCESSORYgreen & orange+ignition harness
SECOND ACCESSORYred or RED / wht+ignition harness
TACHOMETERNOT GREEN/ orange *8ign coil, coil pac, injector
POWER LOCKWHITE/ green *1-driver kick panel
POWER UNLOCKsame wire
PARKING LIGHTS +BLACK / YELLOWrelay under hood at pwr ctr
PARKING LIGHTS -purple / YELLOW *2headlight switch
DOOR TRIGGER*3-*3
HEADLIGHTSpurple / YELLOW *2-headlight switch
WIPERSbrn/wht(L),rd/yel(H)+wiper motor
LF WINDOW UP/DNlt blue - whiteAdriver window switch
RF WINDOW UP/DNbrn/wht - pur/whtAdriver kick panel
LR WINDOW UP/DNRED / blk - blu/whtAdriver kick panel
RR WINDOW UP/DNgrn/wht - gry/blkAdriver kick panel
TRUNK/HATCH PINnone
HOOD PINnone
TRUNK/HATCH RELEASEnone
FACTORY ALARM ARMlt GREEN/ orange *4-driver kick panel
FACTORY ALARM DISARMsame wire
HORN TRIGGERBLACK/ red-steering column
BRAKE WIREWHITE/ tan+brake pedal switch
LOCK MOTORtan/pnk or tan/blkdriver kick panel
UNLOCK MOTORbluedriver kick panel
DISARM DEFEATtan/whitepassenger kick panel
DISARM NO UNLOCKsame wire
DOME SUPERVISIONuse door trigger
SPEED SENSEWHITE/ orangewht conn. 2, pin 27 @ PCM *5
SUN ROOF OPEN/CLOSEnone
SUN ROOF LIMITnone
LF SPEAKERlt grn/rd-lt grn/grnradio or amplifier *6
RF SPEAKERlt blu/pu-lt blu/blkradio or amplifier *6
LR SPEAKERwht/red - wht/blkradio or amplifier *6
RR SPEAKERtan/pur - tan/blkradio or amplifier *6
RADIO 12Vpink+radio
RADIO GROUNDBLACK/ green-radio
RADIO SWITCHBROWN / red+radio
RADIO ILLUMINATEORANGE / blue (dimmer)+radio
POWER ANTENNAnone
 
Notes:NOTE: Chrysler vehicles that use a gray ignition key have an immobilizer system that needs to be bypassed when remote starting. Use DEI part number 555C or 555U. *1 Lock requires a negative trigger thru a 820 ohm resistor. Unlock requires a negative trigger thru a 330 ohm resistor. MUST use relays. *2 Parking lights require a negative trigger thru a 330 or 1.4K ohm resistor. Headlights require a negative trigger thru a 1.8K ohm resistor. There is a rest resistance on the wire, so MUST use a relay to isolate away from the switch. *3 The LF door trigger is tan, and the LR door is tan/orange or PURPLE / orange. These wires are in the driver kick panel. The RF door trigger is tan/red, and the RR door is tan / YELLOW. These wires are in the passenger kick panel. Use all wires and diode isolate each. See directfax document #1076 for wiring information. *4 This will also do door locks. Arm/lock is negative trigger thru a 2K ohm resistor. Disarm/unlock is negative trigger thru a 480 ohm resistor. Single pulse will do disarm without unlocking the doors. Unlock requires a double pulse. MUST use relays. *5 The PCM (Powertrain Control Module) is on the passenger side firewall. *6 The amplifier is located behind the glove box. *7 These wires may not be necessary for remote start. *8 Diesel tach wire use gray/black in the black plug at the PCM.


Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Saturday, April 27, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer