1994 325is/ 1992 acura legend with Bose

In need of the radio diagrams for a acura legend and and bmw and also the alarm system diagrams for bothHarlem00

DIRECTWIRE™ WIRING INFORMATION - ACURA / LEGEND / 1992 / Remote Start 12volts white    +   ign harness or fusebox Starter BLACK/ white    +   ign harness or fusebox Second Starter           Ignition BLACK / YELLOW    +   ign harness or fusebox Second Ignition           Third Ignition           Accessory yellow    +   ign harness or fusebox Second Accessory           Keysense           Power Lock GREEN / WHITE    -   door lock module Notes: Door lock module and factory anti-theft mounted together between column and center console above the accelerator pedal - can also use BLACK/ white and BLACK/ red here for locks. Power Unlock GREEN/ red    -   door lock module Notes: Door lock module and factory anti-theft mounted together between column and center console above the accelerator pedal - can also use BLACK/ white and BLACK/ red here for locks. Lock Motor           Unlock Motor           Parking Lights+ RED / black      dr. kick panel/fusebox Parking Lights- RED / green      at steering column Hazards           Turn Signal(L)           Turn Signal(R)           Reverse Light           Door Trigger wht/blk or blk/wht    -   plug above dr. kick Dome Supervision           Trunk/Hatch Pin GREEN/ black    -   plug back of cluster Hood Pin yellow/red    -   at anti-theft module Trunk/Hatch Release WHITE/ black    +   dr. kick/rear harness Power Sliding Door           Factory Alarm Arm GREEN/ YELLOW    -   at anti-theft module Factory Alarm Disarm GREEN/ red    -   at anti-theft module Disarm No Unlock           Tachometer blue/silver dots   AC   back of dash or Notes: Tach wire located at 12-pin green plug at back of instrument cluster, or at tach test connector by passenger side shock tower - single wire w/plug. Wait to start           Brake Wire GREEN / WHITE    +   brake pedal switch Parking Brake           Horn Trigger blue/red    -   steering column Memory Seat 1           Memory Seat 2           Memory Seat 3           Immobilizer Bypass Module: Required: No Type: N/A Part #: N/A Notes: N/A        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. DIRECTWIRE™ WIRING INFORMATION - ACURA / LEGEND / 1992 / Audio [PRINT THIS PAGE] Radio 12v WHITE/ yellow    +   radio Radio Ground black    -   radio Radio Ignition yellow/red    +   radio Radio Illumination RED / black    +   radio Factory Amp Turn-on           Power Antenna yellow/white    +   radio LF Speaker +/- blu/grn - gry/blk      radio RF Speaker +/- RED / grn - brn/blk      radio LR Speaker +/- blu/yel - gry/wht      radio RR Speaker +/- RED / yel - brn/wht      radio Immobilizer Bypass Module: Required: No Type: N/A Part #: N/A Notes: N/A        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. DIRECTWIRE™ WIRING INFORMATION - BMW / 3 SERIES / 1994 / Security [PRINT THIS PAGE] 12volts RED / wht or red    +   ignition harness Starter blk/yel or grn/blk    +   ignition harness Ignition green    +   ignition harness Power Lock WHITE/ red    +   factory alarm plug Notes: The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange; Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point. Power Unlock blue/red    +   factory alarm plug Notes: The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange; Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point. Lock Motor           Unlock Motor           Disarm Defeat           Parking Lights+ gry/pur, gry/yel      headlight switch Notes: These wires are the separate left and right parking light wires. Use both wires and isolate each. Parking Lights- blue/green (hazards)      factory alarm plug Notes: The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange; Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point. Hazards           Turn Signal(L)           Turn Signal(R)           Door Trigger      -   factory alarm plug Notes: The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange; Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point. Door triggers are BROWN / gray for the drivers front door, BROWN / blue for the passenger front door, and BROWN / white for the rear doors (if equipped). Use all three wires and diode isolate each. If the left rear door does not trigger your alarm system, then remove the diode on the BROWN / white. Dome Supervision comes on with unlock        Trunk/Hatch Pin BROWN / white    -   factory alarm plug Notes: The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange; Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point. Hood Pin PURPLE / green    -      Notes: On early production models the hood pin wire can be found at the radio harness or at the hood pin switch. On later models the hood pin is located in a single pin connector next to the factory alarm plug. Trunk/Hatch Release           Power Sliding Door           Factory Alarm Arm           Factory Alarm Disarm           Notes: If equipped with a factory alarm, the alarm will be plugged into the factory alarm plug. The only way to arm and disarm the factory alarm is with the factory remote. If your planning on using the 8360 pre-wired alarm harness the factory alarm must absent or removed. Disarm No Unlock           Tachometer black   AC   instrument cluster Notes: The wire is located in a white connector behind the instrument cluster. Do not unplug the white connector with the ignition on or turn the ignition on with the plug disconnected. Horn Trigger BROWN / red    -   steering column Memory Seat 1           Memory Seat 2           Memory Seat 3           Immobilizer Bypass Module: Required: No Type: N/A Part #: N/A Notes: N/A        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.