95 Acura Integra GSR 2dr

This will be my first time installing an alarm in a car. I have a few questions. Are the doors on my car negative type? Are the wires that I'm supposed to splice into the ones that are under the dash on the drivers side near the fuse panel? Any help would be appreciated.

Negative type DIRECTWIRE™ WIRING INFORMATION - ACURA / INTEGRA / 1995 / Security 12volts white (50A)   +   ignition harness Starter BLACK/ white   +   ignition harness Ignition BLACK / YELLOW   +   ignition harness Power Lock BLACK/ white   -   driver kick panel Notes: In the larger of two attached gray plugs in the lower kick near the firewall. If equipped with cruise control, the plugs are behind the module. To access, remove the lower bolt on the bracket holding the module and pull it up out of the way. The lock wires test only with the passenger lock and unlock switch. Power Unlock BLACK/ red   -   driver kick panel Notes: In the larger of two attached gray plugs in the lower kick near the firewall. If equipped with cruise control, the plugs are behind the module. To access, remove the lower bolt on the bracket holding the module and pull it up out of the way. The lock wires test only with the passenger lock and unlock switch. Lock Motor WHITE/ red   5wi lock control unit in driver door Unlock Motor yellow/red   5wi lock control unit in driver door Disarm Defeat no progressive unlock        Parking Lights+ RED / black   +   green plug above fusebox Notes: Also a male blade terminal is available in fuse box. Parking Lights- blue/red   -   factory alarm (if equipped) Notes: The factory alarm is under the driver seat. Hazards same as turn signal wires        Turn Signal(L) GREEN/ blue   +   steering column Turn Signal(R) GREEN/ YELLOW   +   steering column Door Trigger lt. GREEN/ red   -   driver kick panel Notes: Looks like 14 awg wire but mostly insulation. In the larger of two attached gray plugs in the lower kick near the firewall. If equipped with cruise control, the plugs are behind the module. To access, remove the lower bolt on the bracket holding the module and pull it up out of the way. Dome Supervision use door trigger        Trunk/Hatch Pin green   -   blu 12 pin plug, top ctr of fuse box Hood Pin yellow/red   -   driver kick panel Trunk/Hatch Release N/A        Power Sliding Door N/A        Factory Alarm Arm factory remote only        Factory Alarm Disarm factory remote only        Disarm No Unlock factory remote only        Tachometer blue   ac   distributor Notes: Also found in a 16 pin white or gray plug to the left of the fuse box. Horn Trigger gray to blue/green   -   steering column Memory Seat 1 N/A        Memory Seat 2 N/A        Memory Seat 3 N/A        Interface Module: Category: Immobilizer Bypass Required: No Type: N/A Part #: N/A Notes:        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.