2005 chevy 2500hd remote start

12volts      red (40A), red (40A)       +       ignition harness Starter      yellow       +       ignition harness Second Starter      N/A             Ignition      pink       +       ignition harness Second Ignition      white       +       ignition harness Notes: To avoid the check engine light from coming on and possible damage to the automatic transmission, the second ignition in this vehicle MUST be powered when adding a remote start system. Third Ignition      N/A             Accessory      orange       +       ignition harness Second Accessory      brown       +       ignition harness Keysense      lt. green       -       ignition harness Power Lock      use 457G or 456G module             Notes: If Directed module 457G or 456G is not available, refer to DirectFax document 1601. On base model trucks, the 457G or 456G is not necessary. Instead, the lock wire is lt. blue (-), pin B5, and the unlock wire is white (-), pin B10. They are in the lt. blue plug at the BCM. Power Unlock      see power lock             Lock Motor      gray       5wi      driver door module in door Unlock Motor      tan       5wi      driver door module in door Parking Lights+      brown       +       driver kick panel Parking Lights-      gray/black       -       switch or BCM, brown plug, pin B2 Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back. Hazards      white       -       hazard switch Turn Signal(L)      dk. green       +       turn signal switch Turn Signal(R)      lt. green       +       turn signal switch Reverse Light      lt. green       +       BCM, black plug, pin F Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back. Door Trigger      gray/blk (L), BLACK/ wht (R)       -       each door module in each door Notes: On base model trucks, the door trigger wires are in the lt. blue plug at the BCM, pins B4 and A5. On 4dr trucks, the LR door trigger is lt. blue/black, pin A3, and the RR is lt. GREEN/ black, pin A2. They are in the purple plug at the BCM. Use all wires and diode isolate. The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back. Dome Supervision      gray/black       +       BCM, black plug, pin E Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back. Trunk/Hatch Pin      N/A             Hood Pin      N/A             Trunk/Hatch Release      N/A             Power Sliding Door      N/A             Factory Alarm Arm      arms on lock with door open             Factory Alarm Disarm      lt. green       -       driver door module in door Disarm No Unlock      see factory alarm disarm             Tachometer      white       ac       instrument cluster, pin A5 or PCM Notes: The PCM (Powertrain Control Module) is in the left front of the engine compartment to the left of the fan shroud. On gas models, the tach wire is in the green plug, pin 10. On diesel models, the tach wire is in the gray plug, pin 37. On hybrid models, the tach wire is in the green plug, pin 35. For tach can also go to any of the ignition coils or fuel injectors and use the wire that is NOT pink, black, or brown. Wait to start      dk. blue       -       instrument cluster, pin A2 or PCM Notes: The PCM (Powertrain Control Module) is in the left front of the engine compartment to the left of the fan shroud. The wait to start wire is in the blue plug, pin 26. Brake Wire      white       +       brake pedal switch Parking Brake      lt. blue       -       switch or BCM, lt. blu plug, pin A7 Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back. Horn Trigger      BLACK / YELLOW to black       -       switch or BCM, gray plug, pin B9 Notes: The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back. Memory Seat 1      red       +       driver door module in door Memory Seat 2      pink       +       driver door module in door Memory Seat 3      N/A       +       Interface Module:      Category: Immobilizer Bypass      Required: Yes      Type: Passlock II Part #: 556LW Alternate Part1 #: 555LW Alternate Part2 #: 555T Alternate Part3 #: DesignTech 20402 Alternate Part4 #: DesignTech 29402 Notes: Not required if using the combo interface module. The Passlock II wire colors are yellow, black, and RED / white (not used). Interface Module:      Category: Door Lock Interface      Required: Yes      Type: Data Bus Part #: 456G Notes: Not required if using the combo interface module. Interface Module:      Category: Combo Interface      Required: Yes      Type: Data Bus Part #: 457GW Notes: