Remote start add on, 01 Dakota

Hey everybody. I need some help! I've got a Scytek galaxy 2000RS remote start add-on module installed in an 01 Dodge Dakota with factory keyless entry. I'm having trouble figuring out how to use the lock pulses to start the vehicle. The WHITE/ green wire in the central timer module is the lock/unlock. When the remote start is wired to the WHITE/ green wire nothing happens when you lock the the doors 3 times. I've tested the remote start by tapping ground 3 times and it starts. So is it not getting a true ground from the lock/unlock? There are 3 different settings for pulse length in the remote start module. Any ideas? Statik

It's definitely not going to work off of the factory lock/unlock wire, since that wire goes through resistors. Try hooking it up to the lock motor lead instead. You may also need a relay to get a (-) output from the lock motor lead, which you could hook up as follows: 85, 87 - ground 86 - lock motor lead 30 - remote start 3 pulse wire.C Renner's Auto Electronix

My service is cheap, quick, and good - pick any two

ORANGE / black stripe, Connector 2, pin 4 at the central timer module...should read ground normally and go to 12v+ when lock is pressed.C Renner's Auto Electronix

My service is cheap, quick, and good - pick any two