2006 Mitz. Raider, 2005 Dodge Dakota

Home / the12volt's Install Bay / Mobile Video, GPS, and Navigation / 2006 Mitz. Raider, 2005 Dodge Dakota (

Topic Closed)

Welcome Guest :)

Members

Next Page > < Prev Topic Next Topic >

Hurricaneduke

Member - Posts: 32

Joined: August 15, 2005

Location: United States

Posted: May 07, 2006 at 7:50 PM / IP Logged

Anyone got VSS, and Reverse Signal locations and colors for these trucks please....thanks

Hurricaneduke

Member - Posts: 32

Joined: August 15, 2005

Location: United States

Posted: May 08, 2006 at 11:14 AM / IP Logged

Hurricaneduke wrote:

Anyone got VSS, and Reverse Signal locations and colors for these trucks please....thanks

I'm installing a Pioneer AVIC-N2 and wondering if the GPS will still work if i don't connect VSS. Or is there any other alternative, since I can't locate the VSS.

extreme1

Silver - Posts: 1,070

Joined: February 12, 2003

Location: Canada

Posted: May 08, 2006 at 5:53 PM / IP Logged

vss is only available on the CAN-BUS or via one of the wheel speed sensors.

Reverse wire is Dark GREEN/ Purple in the drivers kick panel going to the rear of the vehicle.

Shaughn Murley

Install Manager, Dealer Services

Visions Electronics

Red Deer, Alberta

Hurricaneduke

Member - Posts: 32

Joined: August 15, 2005

Location: United States

Posted: May 08, 2006 at 6:50 PM / IP Logged

AVIC-N2 Install. I just got everything together and the unit doesnt turn on. I hooked everything up and grounded everything that is needed. Could this be from a bad ground??? I also noticed that the wires in the harness are missing some wires to go with them, (some wire connections arent connecting to each other), they arent lined up in the correct terminal. I lost, need some guidence please.

extreme1

Silver - Posts: 1,070

Joined: February 12, 2003

Location: Canada

Posted: May 09, 2006 at 8:07 AM / IP Logged

there also isnt' a switched wire in the radio harness, go to the lower left lighter and grab the pink / YELLOW to go to the red wire of the avic.

Shaughn Murley

Install Manager, Dealer Services

Visions Electronics

Red Deer, Alberta

Hurricaneduke

Member - Posts: 32

Joined: August 15, 2005

Location: United States

Posted: May 09, 2006 at 8:29 AM / IP Logged

extreme1 wrote:

there also isnt' a switched wire in the radio harness, go to the lower left lighter and grab the pink / YELLOW to go to the red wire of the avic.

Not sure where the lower left lighter is......

extreme1

Silver - Posts: 1,070

Joined: February 12, 2003

Location: Canada

Posted: May 09, 2006 at 1:06 PM / IP Logged

You have two lighter sockets one on the left and one on the right, the one on the left is switched power

Shaughn Murley

Install Manager, Dealer Services

Visions Electronics

Red Deer, Alberta

Hurricaneduke

Member - Posts: 32

Joined: August 15, 2005

Location: United States

Posted: May 09, 2006 at 5:40 PM / IP Logged

extreme1 wrote:

You have two lighter sockets one on the left and one on the right, the one on the left is switched power

I only have one lighter socket (2006 Mits. Raider 4door V8 Durocross 2WD)......Does it have switched?

extreme1

Silver - Posts: 1,070

Joined: February 12, 2003

Location: Canada

Posted: May 09, 2006 at 6:08 PM / IP Logged

is the wire going to it pink / YELLOW?

yes.

Shaughn Murley

Install Manager, Dealer Services

Visions Electronics

Red Deer, Alberta

Hurricaneduke

Member - Posts: 32

Joined: August 15, 2005

Location: United States

Posted: May 09, 2006 at 8:42 PM / IP Logged

Cool it works......Now everything is working fine except it thinks im facing sideways or someting....not pointing the right way.....any suggestions, I installed hideaway unit in correct position

Next Page >

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.