karr 2040 pin wire id

Repost I don't know why my post has such large font???? I have a 94 Camry LE, with a 2040 or 2040a Karr alarm.

I have searched the net and the 12volt.com to no end, why can't I find my 13 wire pin out??? Control box is black with 2 dip switches inside.

Door unlock intermitent via FOB command. door unlock operational from door switch.

Parking lights fail to flash when armed/disarmed. parking lights operational at headlight switch. Ihave a 13 wire pin out not 14.

My pin's are as follows

Red12v parking light output

White     I believe this is the parking light output, alway's dead 0vdc

RED / white     12vdc

K/w      Siren output operational

Purple  no connection

Yellow Ign +12v

G/W ???? I belive this is Dome light supervision

blue no connection

Black grnd

Orange starter kill neg

 brn door trigger input neg.

Green trunk input neg, this is going to shock sensor 

 dark green no connection

4 pin shock sensor no dedicated connector

Orange

red

blk

green

A 2 pin Molex connector for LED

A 2 Pin Molex connector for Valet/bypass switch

A 2 pin Molex connector for door lock/ unlock

Can somebody verify my 13 pin wire signal ID???

The reason your door unlock is intermittant is most likely because of the child safety lock feature on your car

If you lock your doors fromthe switch prior to exiting your car it will activate your child safety feature and should not be able to unlock from switch until a door is opened. this can be overriden by simultaneously sending a negative pulse to the child safety wire(blue/red) the same time as the unlock wire (light GREEN/ red)

Check the output of your parking light output. most likely the white wire is the parking light wire. This is best tested with a conventional test light. set the alarm off and check each wire until you find one that has a flashing output. that wire is your parking light output. make sure that wire is connected to a green wire at the bottom of the fuse box