the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

alarm, tach, 2006 qx56


Post ReplyPost New Topic
< Prev Topic Next Topic >
smallbody_rider 
Member - Posts: 9
Member spacespace
Joined: September 14, 2005
Location: United States
Posted: June 07, 2010 at 6:39 PM / IP Logged  

 Here are the schematics I used for reference and I checked the ORANGE / wht wire,which was loacted at the second coil on the right side of the engine. Still no luck with alarm learning.

PART 

COLOR

LOCATION

 12 VOLT CONSTANT   GREEN (+)   IGNITION SWITCH HARNESS
 STARTER  BROWN (+) See NOTE *1  IGNITION SWITCH HARNESS
 STARTER 2  LIGHT GREEN (+) or BLUE/GREEN (+) See NOTE *1  IGNITION SWITCH HARNESS
 IGNITION 1  BLACK/ RED (+)  IGNITION SWITCH HARNESS
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY /HEATER BLOWER 1  RED (+)  IGNITION SWITCH HARNESS
 ACCESSORY /HEATER BLOWER 2  PURPLE (+)  IGNITION SWITCH HARNESS
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  RED / BLUE (+)  IN DRIVERS KICK PANEL, HARNESS heading to REAR of Vehicle
 POWER LOCK  BLUE (Negative (-))  @ DRIVER DOOR MODULE IN DOOR, Pin 4
 POWER UNLOCK  RED (Negative (-)) Requires Double Pulse  @ DRIVER DOOR MODULE IN DOOR, Pin 6
 DOOR TRIGGER  See NOTE *2  @ BCM, See NOTE *3
 DOMELIGHT SUPERVISION  BLUE (-)  @ BCM PIN 63, See NOTE *3
 TRUNK RELEASE  YELLOW/BROWN (-)  @ BCM, Pin 30, See NOTE *3
 SLIDING POWER DOOR  N/A  
 HORN  RED / WHITE (-)  @ STEERING COLUMN HARNESS
 TACH  Any wire NOT BLACK or WHITE/ BLUE (-)  @ ANY IGNITION COIL
 WAIT TO START LIGHT  N/A  
 BRAKE  RED / GREEN (+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   DISARMS WITH UNLOCK, Single Pulse Disarms  
 ANTI-THEFT  TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY  TRANSPONDER @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE *2 LEFT FRONT DOOR TRIGGER IS LIGHT BLUE(-) IN PIN47 .THE RIGHT FRONT DOOR TRIGGER IS RED / BLUE(-) IN PIN 12 . THE LEFT REAR DOOR TRIGGER IS RED / YELLOW(-) IN PIN 48 THE RIGHT REAR DOOR TRIGGER IS RED / WHITE OR GRAY(-) IN PIN 13 .WHEN CONNECTING TO AN ALARM SYSTEM, USE ALL 4 DOOR TRIGGER WIRES AND DIODE ISOLATE. TO CONNECT, SEE DIAGRAM NOTE *3 BCM (BODY CONTROL MODULE ) RIGHT OF STEERING COLUMN.
tedmond 
Gold - Posts: 4,610
Gold spaceThis member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.spacespace
Joined: January 06, 2007
Location: Ontario, Canada
Posted: June 07, 2010 at 7:14 PM / IP Logged  

alarm learning?

you mean tach learning?

make sure the unit is in tach mode and not voltage or alternator sense.

Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
smallbody_rider 
Member - Posts: 9
Member spacespace
Joined: September 14, 2005
Location: United States
Posted: June 07, 2010 at 7:29 PM / IP Logged  

I went through those steps with a bitwriter, I hooked it up and went through all the steps to verify it was in tach mode. According to the programming it should be in tach mode, but it still will not learn the tach of this vehicle. But no matter what I will not give up until it's found.

I feel with all the help and info being provided I'm bound to come across the correct wire, hopefully sooner than later.

Thx

topinstaller200 
Copper - Posts: 164
Copper spacespace
Joined: June 02, 2010
Location: Florida, United States
Posted: June 08, 2010 at 8:34 AM / IP Logged  
try the odd colored fuel injector wire
smallbody_rider 
Member - Posts: 9
Member spacespace
Joined: September 14, 2005
Location: United States
Posted: June 12, 2010 at 2:55 PM / IP Logged  

I would like to say thx to all that give me some help with trying to find the tach for my truck, I finally got it to accept with one of the wires coming from one of the fuel injectors, it was a gray/wht wire. Finished the install and now I can move on to the next project. Thx Guys.

smallbody
Page of 2

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Saturday, May 4, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer