python 592, 97 jeep grand cherokee

Guys the false alarm thing is gone since i hooked up the relay.I Need to get the door triggers working.Still when i set the alarm and open a door the door triggers do not sound the alarm.-= Michael Ingram =-

Did you check the programming on the unit to see if it was programmed for Normally open or normally closed? It may just be a simple programming issue. Have you confirmed that you are getting a ground signal on your door input wire whenever you open the doors?Kenny

Owner / Technician

KKD Garage LLC

Albany, NY 12205

i picked up the diodes.I will go check again to see if the doors are showing ground when opened and make sure the programming is set for normally open.-= Michael Ingram =-

If you are getting a good ground signal on your door input wire then you will not need to go to the separate triggers. I thought you were still having an issue with the false alarm... my mistake. Also just to be sure, you do have the yellow (-) door trigger connected to the green (-) door trigger input on the Python correct?Kenny

Owner / Technician

KKD Garage LLC

Albany, NY 12205

i have a yellow wire from the drivers kick panel connected to the green wire yes,it is wired to that relay i did yesterday.BEfore i put the relay on i was getting that error on the python remote saying door open after i would arm the alarm.Now it is not saying door open anymore,but when i unarm the alarm i get the door trigger message on the python remote.-= Michael Ingram =-

That still sounds weird. If you already have the diodes and you have already tested the separate door triggers then you might as well just connect it and not worry about that relay. I can't say for sure that it has anything to do with that, but its 1 less thing to worry about. Also make sure to check the programming setting for normally open vs. normally closed.Kenny

Owner / Technician

KKD Garage LLC

Albany, NY 12205