python 5401p on 97 f250

So I checked the switch and grounded the nss. Still nothing I put my dmm on the nss wire before I grounded it and had 10v is this normal? I've included pics of the paper work the highlighted ones are not connected.

And you expect us to read that? Just open up the unit and see if the fuse for the lights is in position. Never said to test the voltage on that switch, typical amateur chasing up blind alleys. you're looking for continuity, the voltage there is irrelevant. I asked you to test the voltages at ground and fused inputs after the fuses. How have you grounded it?

Use it's all grounded and the power is good the fuse is in the proper position the lights flash when armed and unarmed.

"It's all grounded and the power is good" Grounded, how, what voltages?

I posted the pics because there are some 200ma outputs on the 24 pin I'm not using thought maybe I needed to be tied in

Have you tested the voltages on the H/3 outputs yet? Pink, pink/white, orange and violet?

All 4 power inputs are at 12.28-12.3v at the connector of the brain measured from the ground at the brain

I checked them when I pressed the remote start was pressed with no voltage

Seems a tad low to me test your meter across your battery please and see if you get the same figures.

So assuming you do that last thing and your meter readings are the same, we are possibly looking at a faulty unit.