evo-one not programming

Anyone installed one of these new Fortin by-passes? I have it all wired up as per the specific install instructions for a Nissan Sentra. All powers up but it will not go past step 5 for programming where the blue led should be flashing. Anyone have any suggestions? I have gone through all my wiring and all is connected and soldered as per instructions.

Make sure your hardware is compatible. In the instructions it will say minimum hardware requirements. Check module to see if it meets requirements

Turns out that the OBD connection was backwards as per supplied instructions. Programmed it to the car then had a hell of a time programming first tech remotes... spoke with four different tech support personnel and still not working... meh going back to Compustar that I know will work.