dball2pro remote pairing

Got it!! Open door Turn ignition on Press and release valet button Press and hold valet button Press lock ( or start button on one button remotes) for one second Release valet and turn ignition off Done!! I was trying to use the dang program button intstead of valet....don't I feel dumb... Anyway thank you so much guys!!! Love this site!!

I am trying to do this same setup. I have the dball2pro installed and the 3x lock start works on the OEM remote. I wanted to add an RF kit but i had a couple questions. Did your antenna plug into the green port on the dball2pro? What RF kit do you have? is your remote 1 way or 2 way?

Also, did you plug the valet button into the black port on the dball2pro? I think there is only one port that it fits into is this correct?

Any DEI RF kit should work. Mine is a two way, one button Python remote. The green plug went to the green port on the dball2pro and the same end as the green plug had a black socket on the antenna cable for the valet switch. If you have an antenna with a valet button built in then you won't need a separate valet button. I believe the two pin black port on the dball2pro itself is for the LED light, which I didn't use because it's only needed if you're setting it up as an alarm system too. Be sure when you flash the dball2pro you pick the RF kit remote you will be using from the list.

The valet switch does not plug into the dball2pro even though it looks like it fits. At least mine didn't.

Ok thanks for the info. Where did you get your kit from? I was trying to make my own and I have the one button 2 way Python remote but I can't figure out the programming part.

You need antenna 6212T to go with that remote. Then just plug it into the dball2pro, open the door, turn key ON, press and release valet button, press and hold valet button and while holding press the one button remote, then release valet button. Done.

Ok, i have that antenna, but the cable i have only has a black connector that goes into the antenna and then a white connector that looks like i would plug in where you plug the xk loader 2 into the dball2pro. it seems like your antenna cable is different because i dont know where to plug the valet switch into (it has a blue connector with two wires).

my cable and antenna are like this: https://www.dropbox.com/s/bm96fj54atfh2qq/2014-12-23%2010.57.44%20pm.png?dl=0 i know they make a white plug to green plug adapter i could get so it will plug into the dball2pro, but then I'm still not sure where to plug in the valet switch to program. Did you buy yours all as a kit? or did you buy a certain RF kit?

That antenna should have another cable with it. Mine came as a complete kit Python 4210p but they have a bunch of similar units 4X10 where the X indicates various numbers. The 4 means it's a remote start only, the 2 means it's a 2 way system the 10 is the all in one platform. They also make a 5x10 system just meaning it's also an alarm.