Compustar Reservation Mode Not Working

@tianot When relearning the tach sense I get a 1 siren chirp and a parking light at the same time. After pulling the ebreak and remove my foot off the foot break heard a click sound as soon as my foot release the break, the engine dies immediately when I turn the key off. @ted Almost all of my options are in default (Option 1) exept for the following 1-09 - Option 3 1-14 - Option 3 4-02 - Option 2

your one siren chirp is a good tach. enter reservation mode again, after you remove your foot take a look at your dash lights. wait until it flashes once, then stays dim(approximately 3 seconds) Now remove your keys. vehicle should stay runningTed

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

Hi ted, My dash lights won't flash after removing my foot off the break just a click sound. Thanks

check your ebrake wire? check also your foot brake? if you got a good foot brake wire, it might be your foot brake switch is bad.tianot

Hi Tianot, What do you mean that my foot break switch is bad? how will I verify this? When I set my ignition controlled lock to Option 2 as soon as I step in my breaks the doors lock. Thanks

Just to add, as soon as I pull the ebreaks and my ebreak lights in the dashboard know lights up my doors unlock. I am really starting to think I have a bad brain, probably it got affected when my car got grounded. Would this be possible? Thanks everyone

as tianot said, you have the wrong brake wire most likely. Pull out a meter set to DC black to ground, red to brake wire. When brake is pressed it should show 12v.Ted

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

Test and verify every wiring connection.

i think your problem is you did not power up your IGN2. so what happen is when u set the car to reservation mode, the car won't stay run because the ign2 was not powered up. connect your IGN2 to the blue heavy gauge wire of cm7000 (this is a programmable relay, make sure the jumper connector is set to ign2). and your IGN1 wire is connected to CM7000 green heavy gauge wire. tianot

I was under the impression it remote starter after another installer connected the 2nd ign. It worked for sometime, then stopped working.Ted

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert