Ford Mondeo TDCi Wagon 2013/2014

Home / the12volt's Install Bay / Vehicle Wiring Information & File Requests / Ford Mondeo TDCi Wagon 2013/2014

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

tencap

Member - Posts: 4

Joined: March 16, 2015

Location: Australia

Posted: June 03, 2016 at 9:10 PM / IP Logged

Hi just a request for alarm wiring for Aus RHD Ford Mondeo 2013/2014.

I've looked at the other Ford wiring in the install bay but none are applicable for the Mondeo.

Thanks in advance!!

Back to Top

tonanzith

Gold - Posts: 593

This member consistently provides reliable information

Joined: July 18, 2008

Location: Washington, United States

Posted: June 05, 2016 at 12:08 AM / IP Logged

Which is it 2013 or 14? And I will pull wiring. It SHOULD be the same or very similar to the ford fusion. My understanding is it is a fusion branded as a mondeo in certian countries.

Gary Sather

Back to Top

tencap

Member - Posts: 4

Joined: March 16, 2015

Location: Australia

Posted: June 05, 2016 at 1:40 AM / IP Logged

Hello thanks! It's a 2013, I've looked at the Fusion wiring in the install bay and no colours match and there is no 26pin plug on the fuse/smart juction box.

Back to Top

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: June 05, 2016 at 2:33 AM / IP Logged

Ford Euro software is a nightmare for DB-ALL2 don't even attempt a hard wire.

Back to Top

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: June 05, 2016 at 2:38 AM / IP Logged

There's a DB-ALL 2 set up for the 13 model. 14 was the belated change-over to match the Fusion and Mazda 6, body and ELECTRICS completely different.

Go to a DEI dealer for the alarm and the DB-ALL 2, make sure the dealer flashes the DB-ALL 2 for you and supplies a wiring diagram.

Using a DB-ALL2 as W2W, i.e. connecting the dotted as well as the solid lines in the diagram can be done on the bench pre-installation it will save you hours!

And remember to connect the ignition wire,

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.