Small MDF cuts

Home / the12volt's Install Bay / Car Audio / Small MDF cuts

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

fluidics

Member - Posts: 9

Joined: August 15, 2016

Location: Texas, United States

Posted: August 16, 2016 at 12:06 AM / IP Logged

I'm trying to figure out how to cut some 3/4 mdf for my new box. I have 6 different 45 degree cuts. The longest side of the trapezoids need to be pairs of 2", 3" and 3.5" (see image below)

https://imgur.com/a/u4GtX

How would you go about cutting the angles into such a small length? Any help or suggestions is appreciated.

Back to Top

i am an idiot

Platinum - Posts: 13,667

This member consistently provides reliable information

Joined: September 21, 2006

Location: Louisiana, United States

Posted: August 16, 2016 at 3:41 PM / IP Logged

Make a 3d drawing. I can not figure out what you are trying to do.

Is that the end of a board that is 10 inches long. If so, a table saw with the blade angled at 45 degrees.

Back to Top

i am an idiot

Platinum - Posts: 13,667

Joined: September 21, 2006

Location: Louisiana, United States

Posted: August 16, 2016 at 3:42 PM / IP Logged

https://imgur.com/a/u4GtX

Back to Top

tonanzith

Gold - Posts: 593

Joined: July 18, 2008

Location: Washington, United States

Posted: August 18, 2016 at 10:30 PM / IP Logged

Table saw..... .. . .

Gary Sather

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.