Wiring diodes, shock, glass sensor

Home / the12volt's Install Bay / Car Security and Convenience / Wiring diodes, shock, glass sensor (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

phamine

Copper - Posts: 88

Joined: March 19, 2003

Location: United States

Posted: July 11, 2003 at 12:20 AM / IP Logged

Where would the diodes go? I read other posts and I'm unclear as to what inline means. Also, Someone mentioned that I should not use the same power wire as the alarm. Right now I have my viper 300+ brain powered to a backup battery. Should I wire these two new sensors to 12volts before the backup battery then?

Back to Top

xetmes

Silver - Posts: 586

Joined: May 18, 2003

Posted: July 11, 2003 at 6:10 AM / IP Logged

the diodes are to isolate the sensors from each other, instead of just tieing the triggers together use diodes. If negative trigger... connect the cathodes(band side) of the each diode to one of the trigger (from the 2 sensors), connect the anode (other side) together and to the alarm

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Wiring diodes, shock, glass sensor

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.