keyless entry & door lock switch conflict

I added aftermarket door lock actuators, factory door lock switches and a remote keyless entry kit. I used this diagram https://www.the12volt.com/images/actuatorrevpol.gif and hooked the alarm unlock output and switch unlock output to the same spot (85), then hooked the alarm lock output and switch lock output to the same spot (86). It works ok like this except that my keyless entry kit is really made to unlock the drivers side first, then the passengers side next (using a seperate wire) IF the unlock button is hit 2x. My problem is, the way its wired up, hitting the unlock button on the remote unlocks both doors at the same time. Now, I was wondering if I hooked the keyless entry unlock output up to the unlock wire on the actuator and put a diode between the alarm unlock wire and the relay to prevent any power from going back thru the wires and unlocking the passenger side if this would work or not. And here is a diagram of what I am thinking of trying http://home.austin.rr.com/waterdogs2/relayedit.JPGThanks!-Rob

you need to hit the motor wires in the drivers door.. http://wiringinstructions.com/220.htmGood Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

you mean the wires from the alarm, hook them straight up to the actuator instead of going thru the relay?

no click and paste the above site that i posted for youGood Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

btt