how to make speaker rings

whats the best way to do this...I tried with a jig saw and I suck...is there a better way I heard about routers but don't have one...please let me know what is the easiest way to do this thankyou..

Jer

I have always cut the inner circle first then the outer that way there is enough material for the foot of the jigsaw to rest on.

Gary

OK

Well, I think the idea is to use the roto-zip with a circle jig, do the outside ring first so that the jig still has a place to hold to for the inner circle, then do the inner and not car if the circle is perfect, because it should not be to far off to begin with and then the outside will more than likely be covered with fiberglass, and the inside will be covered with a speaker.

Matt

do you have a router table? if so dril a small hole abot  1/ the diameter of the circle you want to cut in to your table and take your raw sheet drill a hole into that one ( the same size as the one in the table about large enuf to get a screw or a small bolt into ) match the holes put your screw into it turn the router on and just spin the board. perfict circles everytime.

just make sure to do the outter cuts first .