Viper 1200.1 Outputs?

Home / the12volt's Install Bay / Car Audio / Viper 1200.1 Outputs? (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

pilyo143

Member - Posts: 12

Joined: March 10, 2004

Location: United States

Posted: May 06, 2004 at 11:38 PM / IP Logged

I was looking at viper 1200.1 manual and I'm confuse because it's a mono amp with two speaker output. The manual said they are internally parallel. How do you connect a two 12 inch dual 4 ohms diamond m6 to get a 1 ohm load. Do you wire the subs parallel 2 ohm load and then just connect one sub to one terminal. Repeat the same process on the other one. You basically wire one sub 2 ohms to the 1st speaker terminal and the other sub 2ohms also to the 2nd speaker terminal. The amp terminal are parallel inside making it to 1 ohm load the sub are not wired together but the amp terminals are. Did i get it right. Thanks in advance

Ketel22

Silver - Posts: 976

Joined: August 23, 2003

Location: United States

Posted: May 07, 2004 at 3:35 AM / IP Logged

yes that is completely correct.

Quad L Handyman services

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Viper 1200.1 Outputs?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.