Installing Viper 560XV in a 98 S-10

Thank god, lol, I didn't want to deal with that stuff too. lol.

That's what I was thinking about the netural safety switch. Plus I can't even get my key out with the truck not in parl so I didn't really understand the point of it.

Thanks for all the help.

Ok, I've got a few more questions. I just got my alarm today, and I've opened it and looked at it, I think I'm ok on 90%, Here is my major question. I have a 4 wire plug on the relay satellite wiring. I've got the ribbon ok, I've got the large gauge wires ok, ecept way do I have two 12Vconstants. Also, There is a little 4 wire haress with this harness I have no clue what's going on with this. The wire are as follows.

Blue (-) Status out put, ORANGE (-) 200mA 2nd assessory output, PURPLE (-) 200mA starter output, PINK (-) 200mA 3rd ignition output.

I have no clue what to do with this harness I didn't see it in the book at all.

dont use this 4 pin harness... it's for powering extra relays ( 2nd starter, 2nd Acc, etc )  use the status wire ( if needed )  that is in the plug with your brake wire and nuetral safety wire.....

you have 2) 12 v constants to split the current load... you are energizing 4 separate circuits... hook them both up as well as the fused red wire in the flat secondary harness