04 Chevy Colorado, Keyless entry, Viper x791

I usually put the brain in the top left of the underdash basically behind the headlight switch. I zip tie it to that large metal beam. Pop out the little oval shaped piece on the left side of the dash to reveal large bolts to use for a ground. To the right of/below the headlight switch is a large green??? plug which you can grab all your ignition wires in. You can find a thicker constant wire to the left of the plug with your ignition wires. Parking lights you can grab right at the back of the headlight switch BROWN / white (-). Brake switch is wide open.. Putting the module there keeps majority of your wires extremely short and concentrated in one area. Once the dash is put back on it's also difficult to reach. If you want to get a little trickier go right ahead I haven't done any alarms just remote starts/keyless so stealth wasn't my main goal. Oh and Jimmy, for the last time CODE ALARM DOES NOT MAKE THE PLXR! Mike

Mike thanks for the info I plan to have a piezo siren very near to that location and about in same location on passenger side I think I'm just gonna get everything laid out and see how far I can reach with wiring etc... as I do not want to extend any wires nad the shorter the better.

no slo n low...the stores in ohio and georiga are spelled audiovisions and the store i install for is audiovizions

Good that you do not work for that chain of stores if you did I was gonna post some of the work I've seen them do..............it is truly scary stuff