Transponder and Viper 550esp

I installed a viper 550esp and I also needed a transponder bypass.  The only problem that I am having is that I need a neg output from the alarm when remote start is activated. I was told to use the WHITE/ blue wire from the alarm which is a remote start activation input. But I need an neg output.  When I remote start  it, the transponder is not acitvated. If I physically ground the transponder wire and then  remote start  it works fine.  Does anyone know what wire I have to use to get a neg(-) output from the alarm when remote start is activated? Thanks alot...

Also, if you're using the third ignition wire, the blue status output in the 6-pin harness will work.  C Renner's Auto Electronix

My service is cheap, quick, and good - pick any two

the blue status output is the one you need cause it sends a ground pulsed info signal to the transponder do this and your good to go this is the right way to do it. Jon

Installer/Help Technician

---coral springs florida---

mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.

I have a 550esp and I used the H3/1 blue wire, use a relay if its a manual transmission, I used it on an Integra 5 speed, the rookie!~

I used the blue wire, It works good.  Thanks alot for the help..