Valet 562T remote starter and more

I use Corel Draw 10 to make up my own diagrams. Super easy , but does take time to do.

Thanks for the diagram.. But where do I use the relays at? Do I use them at the ends of the lock / unlock wires? 

Also where would I find them? Would they have them at radio shack or something?

POWER LOCK      ORANGE / black           gray 24-pin plug @ bcm                Lock and unlock use the same wire. Lock requires a negative trigger with a 470 ohm resistor in-line. Unlock is negative trigger. Must use relays. See

The above information that was posted before is where you can locate the lock/unlock wire and the output from the  RS/alarm system is required  for pins 85 on each relay. I suggest that if you can not properly read the relay diagram to give this to a professional installer incase you damage something worth more than the cost to get it installed professionally.

Velocity Motors

Sorry, I didn't that a close enough look at it the first time. I thought the black boxes that you had on there were the door lock units.... My Bad.... I understand it now that I have taken closer look at it. I will print it off and give it a try.

But are these relays something that I can get from Radio Shack?

Yes you can get these at any RS, Circuit City, Best Buy or Canadian Tire

IS THIS THE ONE?

\I just wanted to make sure this is the right one that I need. The letters are different then the ones you listed. But it's the only 30amp one that I seen there.

Thanks again for your time

Dave

Velocity Motors

Are these the right style of relay?