Compustar 2W900FMR ground when armed

Home / the12volt's Install Bay / Car Security and Convenience / Compustar 2W900FMR ground when armed (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Raymond4646

Copper - Posts: 121

Joined: July 10, 2005

Posted: August 16, 2006 at 12:50 PM / IP Logged

I installed a DEI 530t window automation in a 03 Eclipse and the one touch function works fine, but when I went to hookup the orange (ground when armed input) of the 530t to the purple (ground when armed output) prewired starter kill relay from the compustar the windows roll up as soon as the key is taken from the ingition. However if I remove the relay from the prewired starter kill harness this does NOT happen and the windows roll up when armed. Per Compustars directions both the red and RED / white wires are given 12volts constant. I did not hookup the additional 2nd assessory relay as I did not need it. Can anyone offer an advice. Thank you!!

bbtaco

Copper - Posts: 119

Joined: November 03, 2002

Location: Virginia, United States

Posted: August 16, 2006 at 1:03 PM / IP Logged

You need to put a diode in the purple wire between the orange wire from the 530T and the starter kill relay. You are getting a ground feed back to the 530T when you shut off the ignition. Make sure the stripe on the diode is facing away from the relay. You can use a 1N4001 1 amp diode.

Raymond4646

Copper - Posts: 121

Joined: July 10, 2005

Posted: August 16, 2006 at 2:28 PM / IP Logged

Thank you very much!!!!!

bbtaco

Copper - Posts: 119

Joined: November 03, 2002

Location: Virginia, United States

Posted: August 16, 2006 at 6:26 PM / IP Logged

You are welcome.

Raymond4646

Copper - Posts: 121

Joined: July 10, 2005

Posted: August 18, 2006 at 3:08 AM / IP Logged

I tried the diode on the orange wire of the 530t with the diode stripe facing away from the starter kill circuit, still does not work. I tried it the opposite way as well. I'm still having the windows roll up as soon as the key is taken out of the ignition. If I take the relay out of the relay harness, then the windows only roll up when armed. I've went back over the wiring and cannot see how the starter kill could be wired incorrectly. Thanks for any help.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Compustar 2W900FMR ground when armed

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.