alarm works but remote start dosen't

ok im a moreon i forgot to turn on the toggle switch but now it turns on but dosent start can you help from there

Give us the wiring that you had used on the truck and the wires you used on the remote starter. Did you power up all the accessory & ignition wires ?? Here is the wiring diagram for the truck.......match the wires tot his diagram:

|       ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        |

|              12V|red or pink/black   |+  |ignition harness            ||          STARTER|yellow              |+  |ignition harness            ||         IGNITION|dk. blue            |+  |ignition harness            ||        ACCESSORY|BLACK/ orange        |+  |ignition harness            || SECOND ACCESSORY|BLACK/ white         |+  |ignition harness            ||       POWER LOCK|ORANGE / purple       |+  |blue plug in                ||     POWER UNLOCK|pink/purple         |+  |drivers kick panel          ||       LOCK MOTOR|ORANGE / black        |   |drivers kick panel          ||     UNLOCK MOTOR|blue                |   |drivers kick panel          ||    DISARM DEFEAT|pink/black          |   |drivers kick panel          || PARKING LIGHTS +|BLACK / YELLOW        |   |*1                          ||       HEADLIGHTS|lt. green           |-  |steering column             ||     DOOR TRIGGER|blk/blu & tan/red *2|-  |*1                          ||  TRUNK/HATCH PIN|tan/black           |-  |*1                          ||  FCTRY ALARM ARM|arms with lock      |   |                            ||FCTRY ALRM DISARM|lt. GREEN/ orange    |-  |*1                          ||       TACHOMETER|BLACK/ gray          |   |ignition coil               ||       BRAKE WIRE|WHITE/ tan           |+  |at brake pedal switch       ||     HORN TRIGGER|BLACK/ red           |-  |steering column             ||           WIPERS|*3                  |+  |steering column             ||  LF WINDOW UP/DN|lt. blue - white    |C  |at drivers door switch      ||  RF WINDOW UP/DN|brn/wht - brn/wht   |C  |at drivers door switch      ||  LR WINDOW UP/DN|blu/wht - RED / blk   |C  |at drivers door switch      ||  RR WINDOW UP/DN|gry/blk - grn/wht   |C  |at drivers door switch      |

Notes:

*1 Located at a black plug in the drivers kick panel.   *2 The BLACK/ blue catches the drivers door and the tan/red catches all other doors. Use both wires and diode isolate each.  *3 Use GREEN/ red for intermittent, purple for low, and RED / gray high.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Make sure that you have properly programmed tach. You can go straight to the odd color on any fuel injector for this unit. Tach is learned only if the park lights flash during "learn" mode. Make sure to give the system at least 15 seconds during the learning procedure (lights flashing). let go of  program button and wait for lights to turn off. Car should start no problem.csorb

for the tach it says to hook up hte wire to the TACHOMETER|BLACK/ gray          |   |ignition coil               so i did that and all it does is turn on not start and the lights flash twice. by the book it means that there is no tach or low tach signal.

do the lights come on on the dash board but the the starter dont start?or does nothing at all happen.if nothing at all happens then the tach is not learned