alarm works but remote start dosen't

Home / the12volt's Install Bay / Car Security and Convenience / alarm works but remote start dosen't (

Topic Closed)

Welcome Guest :)

Members

< Prev Page Next Page > < Prev Topic Next Topic >

harlyneisenmann

Member - Posts: 43

Joined: February 08, 2003

Posted: February 09, 2003 at 6:42 PM / IP Logged

diodes?

Search for other posts by harlyneisenmann

csorb

Copper - Posts: 317

This member has made a donation to the12volt.com. Click here for more info.

Joined: December 28, 2002

Location: United States

Posted: February 09, 2003 at 6:48 PM / IP Logged

Yes. In the box came a special connector to be able to connect both the alarm trigger wire and the remote start inhibit wire to the same scource (hood pin). In the black coating over the Y-connector are two diodes. Without those diodes the alarm trigger wire will feed a signal to stop the car from remote starting.

csorb

harlyneisenmann

Member - Posts: 43

Joined: February 08, 2003

Posted: February 09, 2003 at 6:52 PM / IP Logged

you are talking about the black wire with shrink tubing right cause it is installed

harlyneisenmann

Member - Posts: 43

Joined: February 08, 2003

Posted: February 09, 2003 at 6:55 PM / IP Logged

now the code is saying no tach signal

csorb

Copper - Posts: 317

Joined: December 28, 2002

Location: United States

Posted: February 09, 2003 at 6:57 PM / IP Logged

That is correct. Unplug it and try again. Also check the diagnostic code.

csorb

harlyneisenmann

Member - Posts: 43

Joined: February 08, 2003

Posted: February 09, 2003 at 7:03 PM / IP Logged

so now hook up the tach wire and it should work right

harlyneisenmann

Member - Posts: 43

Joined: February 08, 2003

Posted: February 09, 2003 at 7:06 PM / IP Logged

i forgot to hook up the tach wire do you know where the ignition coil is

harlyneisenmann

Member - Posts: 43

Joined: February 08, 2003

Posted: February 09, 2003 at 7:07 PM / IP Logged

or the pcm

csorb

Copper - Posts: 317

Joined: December 28, 2002

Location: United States

Posted: February 09, 2003 at 7:08 PM / IP Logged

Even without the tach wire hooked up, you should still get seven flashes.

Perhaps you accidentaly unprogrammed the remote start button.

To reprogram it,

Turn the ignition key on

press the program button 5 times

hold the green button on the remote so that you hear a long chirp

take out the key.

csorb

harlyneisenmann

Member - Posts: 43

Joined: February 08, 2003

Posted: February 09, 2003 at 7:12 PM / IP Logged

did that wont, start still get 2 flashes

< Prev Page Next Page >

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.