the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2010 Mazda 3 Remote Starter Wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
mi99z71 
Member - Posts: 3
Member spacespace
Joined: November 15, 2004
Location: United States
Posted: September 12, 2009 at 12:48 PM / IP Logged  

Anyone have a wiring diagram for remote start wiring for a 2010 Mazda 3. And also what bypass module would one recommend to do this?

Thanks

Norm

tommy... 
Gold - Posts: 1,901
Gold spacespace
Joined: December 10, 2004
Location: United States
Posted: September 12, 2009 at 2:37 PM / IP Logged  
BatteryYELLOW & ORANGE(+)IGNITION SWITCH HARNESS...EACH OF THESE WIRES IS FUSED AT 40 AMPS2010 Mazda 3 Remote Starter Wiring -- posted image.
2010 Mazda 3 Remote Starter Wiring -- posted image.Ignition 1BLUE(+)IGNITION SWITCH HARNESS
2010 Mazda 3 Remote Starter Wiring -- posted image.Accessory 1PINK(+)IGNITION SWITCH HARNESS
2010 Mazda 3 Remote Starter Wiring -- posted image.Accessory 2WHITE(+)IGNITION SWITCH HARNESS
2010 Mazda 3 Remote Starter Wiring -- posted image.Starter 1LIGHT GREEN(+)IGNITION SWITCH HARNESS
2010 Mazda 3 Remote Starter Wiring -- posted image.Anti-Theft TypeUNIVERSAL IMMOBILIZER
2010 Mazda 3 Remote Starter Wiring -- posted image.Anti-Theft DescriptTHE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER
2010 Mazda 3 Remote Starter Wiring -- posted image.Key SenseLIGHT BLUE(+)IGNITION SWITCH HARNESS
2010 Mazda 3 Remote Starter Wiring -- posted image.Tachometer...USE INJECTOR WIRE2010 Mazda 3 Remote Starter Wiring -- posted image.
2010 Mazda 3 Remote Starter Wiring -- posted image.Speed SenseORANGE(AC)RADIO HARNESS
2010 Mazda 3 Remote Starter Wiring -- posted image.Parking LightsORANGE(+)IN HARNESS IN DRIVER KICKPANEL TO REAR
2010 Mazda 3 Remote Starter Wiring -- posted image.Low Crr. Pk LightsGRAY(-)BCM MODULE...ALSO AT LIGHT SWITCH HARNESS2010 Mazda 3 Remote Starter Wiring -- posted image.
2010 Mazda 3 Remote Starter Wiring -- posted image.Brake LightsGREEN(+)SWITCH ABOVE BRAKE PEDAL
2010 Mazda 3 Remote Starter Wiring -- posted image.Reverse LightsWHITE(+)IN HARNESS IN DRIVER KICK PANEL
2010 Mazda 3 Remote Starter Wiring -- posted image.HornBLUE(-)HARNESS AT STEERING COLUMN
2010 Mazda 3 Remote Starter Wiring -- posted image.CANbusGREEN & GRAY(DATA)OBD II CONNECTOR...THESE ARE CAN MEDIUM SPEED CAN HIGH AND LOW RESPECTIVLY
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!
tommy... 
Gold - Posts: 1,901
Gold spacespace
Joined: December 10, 2004
Location: United States
Posted: September 12, 2009 at 2:38 PM / IP Logged  
Power UnlockLIGHT GREEN(-)BCM MODULE...STRAIGHT (-) FOR LOCK, SAME WIRE FOR LOCK AND FACTORY ALARM CONTROL2010 Mazda 3 Remote Starter Wiring -- posted image.
2010 Mazda 3 Remote Starter Wiring -- posted image.PowerLockLIGHT GREEN(-)BCM MODULE...USE A 1K OHM RESISTOR FOR LOCK, SAME WIRE FOR UNLOCK AND FACTORY ALARM CONTROL2010 Mazda 3 Remote Starter Wiring -- posted image.
2010 Mazda 3 Remote Starter Wiring -- posted image.Driver Mtr UnlockBLUE(AC)BCM MODULE
2010 Mazda 3 Remote Starter Wiring -- posted image.Driver Mtr LockYELLOW(AC)BCM MODULE...THIS WIRE WILL LOCK ALL DOORS2010 Mazda 3 Remote Starter Wiring -- posted image.
2010 Mazda 3 Remote Starter Wiring -- posted image.LF Window UpWHITE/ BLACK(AC)MASTER WINDOW SWITCH
2010 Mazda 3 Remote Starter Wiring -- posted image.LF Window DnWHITE/ GREEN(AC)MASTER WINDOW SWITCH
2010 Mazda 3 Remote Starter Wiring -- posted image.RF Window UpORANGE(AC)MASTER WINDOW SWITCH
2010 Mazda 3 Remote Starter Wiring -- posted image.RF Window DnLIGHT BLUE(AC)MASTER WINDOW SWITCH
2010 Mazda 3 Remote Starter Wiring -- posted image.LR Window UpWHITE(AC)MASTER WINDOW SWITCH
2010 Mazda 3 Remote Starter Wiring -- posted image.LR Window DnVIOLET(AC)MASTER WINDOW SWITCH
2010 Mazda 3 Remote Starter Wiring -- posted image.RR Window UpGREEN(AC)MASTER WINDOW SWITCH
2010 Mazda 3 Remote Starter Wiring -- posted image.RR Window DnVIOLET(AC)MASTER WINDOW SWITCH
  
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!
tommy... 
Gold - Posts: 1,901
Gold spacespace
Joined: December 10, 2004
Location: United States
Posted: September 12, 2009 at 2:39 PM / IP Logged  
Headlights-LoBROWN (-)BCM MODULE...ALSO AT LIGHT SWITCH HARNESS2010 Mazda 3 Remote Starter Wiring -- posted image.
2010 Mazda 3 Remote Starter Wiring -- posted image.All Hazrd LightsWHITE(-)BCM MODULE
2010 Mazda 3 Remote Starter Wiring -- posted image.Parking BrakeVIOLET(-)BCM MODULE
2010 Mazda 3 Remote Starter Wiring -- posted image.Trnk ReleaseBROWN(-)BCM MODULE
  
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!
tommy... 
Gold - Posts: 1,901
Gold spacespace
Joined: December 10, 2004
Location: United States
Posted: September 12, 2009 at 2:41 PM / IP Logged  
Does that have the Smart-Key...? Flash-it.com will tell you what bypass yo use...! FLCAN...FLTB1...FLTBF...Are a few w/o SmartKey...
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!
dennis f 
Member - Posts: 12
Member spacespace
Joined: April 20, 2007
Location: United States
Posted: September 21, 2009 at 2:21 PM / IP Logged  
If this car doesn't have the smart key, can I use a ASTCBM or equivalent and just wire everything else up or is there a better option with a module?
My customer has 2 keys (both with the built in keyless) and some kind of chip or something on a card I have not seen yet.
What are my options?
-Dennis
cdm_sd02 
Member - Posts: 1
Member spacespace
Joined: May 15, 2006
Location: Connecticut, United States
Posted: September 29, 2009 at 6:46 AM / IP Logged  
Thanks for the INFO
mi99z71 
Member - Posts: 3
Member spacespace
Joined: November 15, 2004
Location: United States
Posted: November 09, 2009 at 8:09 AM / IP Logged  

Having a slight problem with install.  Just can't get bypass it work. Using a xpresskit, xk05 with pkti firmware flashing. I can't seem to get module to program.  Just wanted to see if any one could verify colors for the TX and RX  wiring.  When I wired it all up, all the module did was LED was on, then I inserted first key and turned to on position, then led flashed, and came back on. So I switched keys, and tried to program second key, and the LED just stayed on.   There are 4 wires at the connector ( dark blue,  light blue, black, and orange ) in those colors.   Otherwise, module directions state to reset module if it won't program. which in this case involves reflashing it. And I have not don't that part yet.

Thanks

Norm  

jordan_lin 
Member - Posts: 2
Member spacespace
Joined: November 13, 2005
Location: Canada
Posted: March 27, 2010 at 1:28 PM / IP Logged  
Hi there, I am having problem finding the door pin signal on this car. can anyone help?? Thank you
tedmond 
Gold - Posts: 4,610
Gold spaceThis member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.spacespace
Joined: January 06, 2007
Location: Ontario, Canada
Posted: March 27, 2010 at 9:37 PM / IP Logged  

for the bypass there is a 4pin plug at the ignition cylinder.

TX - grey/orange

RX - WHITE/ light green
leave your gwr or status wire unhooked until you are done programming.

For the thread highjacker,

use 4 diodes to diode isolate the wires. diode band towards wire on car.

LF - BLUE (-) @ BCM plug F Pin G

RF  - GREEN (-) @ BCM plug F Pin H
LR - BROWN (-) @ BCM plug F Pin E
RR - ORANGE (-)  @ BCM plug F Pin K

Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Page of 2

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, March 28, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer