'01 maxima push button ignition

2001 maxima se Here’s the wiring diagram |              12V|                      |   green                         |      | + |          ignition harness            | |          STARTER   |             | BLACK/ red or blk/wht     |      | + |          ignition harness            | |   SECOND STARTER|      |    BLACK/ blue                 |      | + |          ignition harness            | |        IGNITION|                 | BLACK/ red (smaller)       |      | + |          ignition harness            | |        ACCESSORY|            | RED / yellow                    |      | + |           ignition harness            | | SECOND ACCESSORY| | WHITE/ blue                    |      | + |             ignition harness           | |       POWER LOCK|           | gray                            |      | - |        pin 23 at SECU *1           | |     POWER UNLOCK|        | BROWN / yel                    |     | - |        pin 35 at SECU *1           | |       LOCK MOTOR|            | purple                         |     |     |        pin 15 at SECU *1           | |     UNLOCK MOTOR|        | WHITE/ black                 |     |     |        pin 13 at SECU *1           | |    DISARM DEFEAT|          | GREEN/ YELLOW               |     |     |        pin 14 at SECU *1           | | PARKING LIGHTS +|        | RED / blue                      |     |     |           driver kick panel *2        | | PARKING LIGHTS -|          | lt. blue                        |     |     |             headlight switch            | |       HEADLIGHTS|             | pink                            |     | - |             headlight relay *7          | |     DOOR TRIGGER|          | *3                               |     |     |               SECU *1                     | | DOME SUPERVISION|      | use door trigger        |     |     |                                                  | | TRUNK/HATCH PIN|        | purple / YELLOW              |     | - |          pin 38 at SECU *1           | NOTE: This vehicle has an immobilizer system that needs to be bypassed during remote start operation. *1 The SECU (Smart Entrance Control Unit) is located to the      passenger’s side of the steering column *2 can also find RED / green or RED / yellow at fuse box Ok What I am trying to do is set it up so that I can start the motor with a push button switch. Let me go more into detail You put the key into the ignition and you turn it to run ( notice I said run not start) then you push this button and the motor starts. So here’s what I did I hooked up to the secondary accessory line so the car is only startable when the key is in the starter. Put a 12v fuse in there for protection. Then the switch it was rated for 12v and was labeled for push button ignition so I didn't feel I needed to use a relay. Then I wired to the starter line. Tried it and nothing. So I tied together both starter lines and still nothing. I grabbed the manual checked what points had continuity between them on the leads on the ignition module. There was continuity between the 12v, starter1, starter2, and ignition. So then I grabbed power from the 12v and wire the push button switch to starter 1, 2, and ignition. After I reconnected the battery I tried it once again and nothing happened. So I’m out of ideas. Does and one have an idea ?

Also, you will need to cut both starter wires in order for this to workJeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA