1994 corvette reverse polarity locks

Home / the12volt's Install Bay / Car Security and Convenience / 1994 corvette reverse polarity locks (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

tony24

Member - Posts: 7

Joined: December 07, 2002

Location: United States

Posted: January 14, 2009 at 3:22 PM / IP Logged

I searched and didn't come up with any information on wiring reverse polarity door locks on a corvette. the diagram sheet says the wires are located in the driver kick panel. I have located the wires for lock and unlock but am confused about cutting them in this location because the diagram shows cutting between the switch and actuator. The wires in the kick panel comes from the switch. Can anyone add any insight to this. The lock wire is rd/blk, unlock or/blk. I'm installing a crimestopper FM two way unit. Thanks.

Mike M2

Platinum - Posts: 2,652

Joined: June 29, 2005

Location: United States

Posted: January 14, 2009 at 6:19 PM / IP Logged

You are cutting them between the drivers switch and the passenger actuator when you tie in at the kick panel.

Mike M2

Tech Manager

CS Dealer Services

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

1994 corvette reverse polarity locks

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.