2014 crv starter problem

I attempted to install a Compustar FT-7200S-CONT with Blade-AL bypass on a 2014 Honda CRV. The blade has been flashed with firmware DL-HA3. I followed the blade guide and connected the wires indicated http://cdncontent2.idatalink.com/corporate/Content/Manuals/DL-HA3/BLADE-AL(DL)-HA3-EN_20141031.pdf Ignition CanH CanL Key Data Lock Unlock Ground WHITE/ Black to Blue / YELLOW On the Compustar 7200 I connected 2x power wires Ignition Starter Accessory Ground I then went to do the module programming but the red light stays steady indicating "Waiting for more vehicle information". So I cannot not complete the programming. When attempting to start the vehicle with the key the immobilizer light flashes and the vehicle will not start I removed the compustar 7200 and left the wiring connected. Still the vehicle will not start. It tries to crank and then sometimes runs for half a second and shuts down. Could someone please help me figure this out. Thanks.

Never mind I rechecked the connections and found one of the solder joints broke off from one of the wires on the blade harness.